Subject	NA cmc/assembly & Z1 dual plate. Still excellent for DD and
Posted by	*BK300ZX* on December 06, 2012 at 10:13 PM
	This message has been viewed 109 times.
In Reply To	Just replace the TT CMC and pedal assembly with an NA posted by TTZEDHEAD on December 06, 2012 at 07:26 PM
Message	I also am using the SS clutch line, 350Z clutch fork, and Nismo throw-out bearing.
Follow Ups	For those with fender braces, where do you mount your clutch - fuzzymonkey 15:52:13 12/06/12 you don't need it - aliaZ 16:06:46 12/06/12 I noticed it when I tracked my Z - ttsmokin 16:27:52 12/06/12 ^^ this - fuzzymonkey 16:32:54 12/06/12 Just replace the TT CMC and pedal assembly with an NA - TTZEDHEAD 19:26:18 12/06/12 2nd. Except I'm using the SZ High-5(puck) Feels nearly - PiotrC70 20:11:18 12/06/12 NA cmc/assembly & Z1 dual plate. Still excellent for DD and - *BK300ZX* 22:13:59 12/06/12 thats an ober lame excuse not to... (n/m) - Dane (Houston) 11:28:12 12/07/12 maybe your check valve was bad? - aliaZ 17:16:10 12/06/12 Didn't feel one bit of difference without it as well (n/m) - KongZTT GT28RS MD 17:32:22 12/06/12 Perhaps, I will check it out - ttsmokin 17:47:53 12/06/12 i've tried two different check valves. - fuzzymonkey 17:56:20 12/06/12 in one of my z's, when I did the auto > 5sp swap - fuzzymonkey 16:29:57 12/06/12 did you install the check valve? (n/m) - aliaZ 17:16:53 12/06/12 yes - fuzzymonkey 17:57:03 12/06/12 You won't even know its gone. Just plug the vacuum hose. (n/m) - RonZ300 (Socal) 16:10:18 12/06/12 there is enough slack in the stock hoses to move it if your - BoneZ (MD) 17:18:48 12/06/12 I relocated mine behind the slash shield. (n/m) - Piranha 17:42:53 12/06/12 is ther a current source (in the us) for the braces? (n/m) - FuerGrissa 20:43:09 12/06/12 I ordered mine from here - aliaZ 12:05:40 12/07/12 Re: For those with fender braces, where do you mount your clutch - Rob260 20:32:25 12/07/12
Post a Followup	You cannot reply to this message because you are not logged in.