Subject	should be fine
Posted by	aliaZ on December 06, 2012 at 12:48 PM
	This message has been viewed 193 times.
In Reply To	bent MAF screen.... is that OK? posted by blackomega on December 05, 2012 at 09:52 PM
Message	it doesn't matter that each wire in the screen is attached, so long as the screen exposed to the airflow is in place. The screen straightens the airflow
Follow Ups	bent MAF screen.... is that OK? - blackomega 21:52:12 12/05/12 You should be fine. (n/m) - Summeronthechain (MN) 21:59:56 12/05/12 one member even removes the rear screen (n/m) - RonDeezy 07:44:09 12/06/12 Not that pretty but you can take soldering iron and melt - craigz96tt 08:28:14 12/06/12 went ahead and installed it... - blackomega 10:10:44 12/06/12 no biggy, you'll be fine (n/m) - RobZ32 11:01:54 12/06/12 cool - blackomega 11:40:18 12/06/12 should be fine - aliaZ 12:48:46 12/06/12 thanks - blackomega 12:26:54 12/08/12
Post a Followup	You cannot reply to this message because you are not logged in.