Subject	Not that pretty but you can take soldering iron and melt
Posted by	craigz96tt on December 06, 2012 at 8:28 AM
	This message has been viewed 182 times.
In Reply To	bent MAF screen.... is that OK? posted by blackomega on December 05, 2012 at 09:52 PM
Message	little tabs all the way around the outer plastic to secure the screen. May not affect it but at a dyno day near me a guy had a ws6 trans am and took the screen off his and lost power. The screen acts as a diffuser so I would leave it on. Just an opinion
Follow Ups	bent MAF screen.... is that OK? - blackomega 21:52:12 12/05/12 You should be fine. (n/m) - Summeronthechain (MN) 21:59:56 12/05/12 one member even removes the rear screen (n/m) - RonDeezy 07:44:09 12/06/12 Not that pretty but you can take soldering iron and melt - craigz96tt 08:28:14 12/06/12 went ahead and installed it... - blackomega 10:10:44 12/06/12 no biggy, you'll be fine (n/m) - RobZ32 11:01:54 12/06/12 cool - blackomega 11:40:18 12/06/12 should be fine - aliaZ 12:48:46 12/06/12 thanks - blackomega 12:26:54 12/08/12
Post a Followup	You cannot reply to this message because you are not logged in.