Subject	No prob. I dont know what that means as far as quality.
Posted by	ZXoltan on December 02, 2012 at 10:12 AM
	This message has been viewed 93 times.
In Reply To	Yes, thanks Brandon, for the clarification posted by white22sky on December 02, 2012 at 09:08 AM
Message	I've heard concerns on this site about the Eagles with the big end sizing being off. Its even possible the problems were with the Scat's and were attributed to the Eagles... ??
Follow Ups	rods and bearings? - sonazty 20:17:45 12/01/12 Scat = Eagle - white22sky 21:24:09 12/01/12 thanks for your input. (n/m) - sonazty 21:42:11 12/01/12 And to clarify, Im not saying quality wise scat=eagle - white22sky 22:29:30 12/01/12 Close, but not exactly the same - ZXoltan 07:42:55 12/02/12 Yes, thanks Brandon, for the clarification - white22sky 09:08:42 12/02/12 No prob. I dont know what that means as far as quality. - ZXoltan 10:12:17 12/02/12 I have also heard that, But Ive heard many more success - white22sky 10:23:25 12/02/12 Re: I have also heard that, But Ive heard many more success - Tech@EPR 18:02:59 12/02/12 machine shop says there's a difference of roughly $8 per rod (n/m) - sonazty 22:00:41 12/02/12 which ACL bearing did you use? - aliaZ 08:31:48 12/03/12 Re: which ACL bearing did you use? - Tech@EPR 08:42:18 12/03/12 interesting...thanks (n/m) - aliaZ 09:21:30 12/03/12 The ACL race bearings are good - aliaZ 06:41:58 12/02/12 i like oem bearings and if $ ok crower rods (n/m) - craigz96tt 08:59:44 12/02/12 Re: rods and bearings? - Cjw3 11:12:12 12/02/12 i will ask the machinist tomorrow if he will do this. (n/m) - sonazty 22:02:49 12/02/12
Post a Followup	You cannot reply to this message because you are not logged in.