Subject	The air cannot be taken in any quicker then it can
Posted by	HighPsi (NorCal) on November 30, 2012 at 4:15 PM
	This message has been viewed 153 times.
In Reply To	Agreed to a point posted by Red Hawk (CO) on November 30, 2012 at 02:24 PM
Message	be let out.
Follow Ups	Perfomance Options - esimplx 12:17:49 11/30/12 These 2 upgrades really compliment each other, - HighPsi (NorCal) 12:37:12 11/30/12 Piping, manifolds, and used intercoolers. Turbos will sing! (n/m) - Lumpydonut 12:40:49 11/30/12 Re: Perfomance Options - TRJohn46 13:04:15 11/30/12 How will 2.5" piping be any sort of performance upgrade - HighPsi (NorCal) 13:35:53 11/30/12 Agreed to a point - Red Hawk (CO) 14:24:53 11/30/12 The air cannot be taken in any quicker then it can - HighPsi (NorCal) 16:15:23 11/30/12 Reading owns me - Red Hawk (CO) 17:48:03 11/30/12 Of course it can. Air is compressible. - ConVerTT 12:55:32 12/01/12 Link >>> 2nd chart in the series - ConVerTT 13:01:23 12/01/12 If mass flow rate in was different than the mass flow rate - turtleboy 00:37:03 12/02/12 No. My statement and conclusion are essentially correct, - ConVerTT 10:28:55 12/02/12 Re: Re: Perfomance Options - esimplx 13:50:21 11/30/12 You just answered your own question. No doubt you would - Mr.Stacy 14:23:12 11/30/12 Manifolds gives you the best platform to build going - bbug 13:22:04 11/30/12 My impression is that you gotta have the I/C's, so: #1 (n/m) - zellamay 13:30:51 11/30/12 Option two is just a different set of ICs with MSP Manis. (n/m) - johnnysombrero 14:03:29 11/30/12 pretty sure 2.5 intake piping is pointless if you are going - LJZTT 14:34:03 11/30/12 Re: pretty sure 2.5 intake piping is pointless if you are going - TTZEDHEAD 19:03:39 11/30/12 Before you make a big investment on parts you should - Krazyd27(Houston) 16:18:19 11/30/12 Re: Before you make a big investment on parts you should - esimplx 16:39:16 11/30/12 Sounds like a solid base for some high powered goals - LivinTheDream 19:21:47 11/30/12 Re: Perfomance Options - TRJohn46 11:40:32 12/01/12 Build thread - esimplx 14:19:29 12/01/12
Post a Followup	You cannot reply to this message because you are not logged in.