Subject	Not with those but I got some Forge adjustables
Posted by	Broke_as_**** on November 29, 2012 at 9:53 PM
	This message has been viewed 256 times.
In Reply To	Experience with Adjustable Wastegate Actuators? posted by RoidRage76 on November 29, 2012 at 08:56 PM
Message	Rather than make new brackets when upgrading to 2854Rs I just drilled out the spot welds holding in stock actuators in and tapped some new holes on the back of the compressor housing. Had to cut the shaft down quite a bit on the drivers side but still had plenty of room for adjustment. Set them for 12 psi and they hold the 20 I've had the car up to on occasion no problem. Setting them up is pretty easy, built a little rig like this one: [ http://www.twinturbo.net/nissan/300zx/forums/technical/view/951601/Turbo-wastegate-setupbalance.html ] I went with Forge because they have a piston setup rather than a diaphragm, they can be rebuilt/have the spring swapped and that's what Kuah told me to buy. Not necessarily in that order.
Follow Ups	Experience with Adjustable Wastegate Actuators? - RoidRage76 20:56:16 11/29/12 Not with those but I got some Forge adjustables - Broke_as_**** 21:53:00 11/29/12 I have the forge ones.. - KongZTT GT28RS MD 23:11:08 11/29/12
Post a Followup	You cannot reply to this message because you are not logged in.