Subject	I have seen the future fuca
Posted by	Dallas DamonZ on September 21, 2012 at 6:00 PM
	This message has been viewed 152 times.
In Reply To	Since RomChip200 brings up a safety issue with FUCA posted by njz on September 21, 2012 at 12:07 PM
Message	and it is from SPL Parts. Those that were at the tt.NET dinner did too. Thanks sfarrah :-) Later When was the last time you *really* did something with your Z to call yourself a Z enthusiast? Member #1 PETZ
Follow Ups	Since RomChip200 brings up a safety issue with FUCA - njz 12:07:32 09/21/12 Seriously, we need a proper A-Arm design conversion solution - ZinnZ32 13:37:22 09/21/12 Nothing "modern" about that design - ZXoltan 14:33:20 09/21/12 Good luck fitting anything like that on a Z32 (n/m) - Bernie (NoVA) 18:39:35 09/21/12 I would attribute rx7 handling to low curb weight and 50/50 - TriniTT 13:18:36 09/22/12 I don't - Insomniac (VA) 15:00:04 09/21/12 I think that it's an over adjustment by the alignment shop - njz 15:15:09 09/21/12 I have seen the future fuca - Dallas DamonZ 18:00:25 09/21/12 Agreed. (n/m) - Bernie (NoVA) 18:31:52 09/21/12 Any estimate on its availability, Bernie? (n/m) - vulcanrush 20:22:30 09/21/12 Re: Any estimate on its availability, Bernie? - MaxxAction 21:11:36 09/21/12 great news. i have been holding out for years for SPL - slayer fan 01:26:14 09/22/12 SPL Arm - Rob260 17:55:09 09/23/12
Post a Followup	You cannot reply to this message because you are not logged in.