Subject	something like this
Posted by	aliaZ on September 05, 2012 at 6:02 AM
	This message has been viewed 331 times.
In Reply To	on a similar note, what are the best multifunction gauges? posted by BlackholeZ on September 05, 2012 at 02:01 AM
Message	[ http://www.innovatemotorsports.com/xcart/product.php?productid=16301&cat=265&page=1 ] The dashdaq: [ http://www.drewtech.com/enthusiast/index.html ] interfaces with the MTS data stream of the innovate motorsports devices, and allows you to customize your gauge display. You can daisy chain other innovate sensor interfaces so that you can have thermocouples, temp sensors, and pressure sensors tied into one gauge interface. I'd probably go with something like this, or a stand-alone. I too don't want eleventy billion gauges cluttering up my dash...
Follow Ups	Dual Wideband? - BlackholeZ 17:40:09 09/04/12 You could move the sensor back and forth, but then - ForceFedTT (SoCal) 18:11:23 09/04/12 Re: I have a dual wide band and dual EGT setup - miloz 01:51:58 09/05/12 How about two sensors? - SactoTodd 18:32:56 09/04/12 Re: How about two sensors? - mpmarino 18:38:05 09/04/12 yes, I have been thinking about that - BlackholeZ 18:44:42 09/04/12 Unless the controllers are wired together - ZXoltan 02:13:21 09/05/12 Sensors don't like being unpowered in exh streams - BlackholeZ 18:42:26 09/04/12 Can you keep them both powered and just switch between - ZXoltan 18:45:54 09/04/12 been thinking about that, see my reply to mpmarino (n/m) - BlackholeZ 20:17:49 09/04/12 that will quickly ruin the sensors (n/m) - aliaZ 20:56:40 09/04/12 Had to be a reason, thanks! (n/m) - SactoTodd 21:55:23 09/04/12 My pleasure, Todd (n/m) - aliaZ 05:53:34 09/05/12 X-pipe Dual Wideband? - mpmarino 19:00:27 09/04/12 I run two LC-1s connected to a single gauge with a toggle - ConVerTT 19:41:02 09/04/12 That is exactly what I have been thinking of doing. (n/m) - Aqualung 22:21:09 09/04/12 I would recommend dual wideband and datalog and not be - The Devils Z 20:09:21 09/04/12 This is just the beginning - BlackholeZ 20:23:22 09/04/12 Do you need an LMA-3? - Dallas DamonZ 16:22:51 09/05/12 2>1 - Alan(MD/NJ) 20:54:58 09/04/12 that is exactly what I do not want - BlackholeZ 01:34:17 09/05/12 This is why my winter mod will be a CARpc - megaDan 08:32:45 09/05/12 You mean... - DVDBURN (MD) 22:42:22 09/04/12 I should see if I can find the stacks of those boxes I have - BlackholeZ 01:36:06 09/05/12 I had the same dilemma when I was about to order widebands - spdrmn15 20:39:03 09/04/12 road racing? ?_? (n/m) - fuzzymonkey 11:47:09 09/05/12 Here - AHos(Chicago) 12:38:40 09/05/12 I have one wideband and a dual EGT gauge - Broke_as_**** 21:25:37 09/04/12 not true -- you will not catch a lean condition quick enough - The Devils Z 13:16:26 09/05/12 How do you figure that? (n/m) - Broke_as_**** 18:04:57 09/05/12 because I have the setup in my Z now and monitor - The Devils Z 18:30:08 09/05/12 Perhaps the disconnect is the defintion of catch - Broke_as_**** 23:30:49 09/05/12 on a similar note, what are the best multifunction gauges? - BlackholeZ 02:01:05 09/05/12 something like this - aliaZ 06:02:34 09/05/12 Very nice... - BlackholeZ 02:01:20 09/06/12 Re: Dual Wideband? - 2+2Twin Turbo 08:38:11 09/05/12 Re: Re: Dual Wideband? - tacozzz 12:49:09 09/05/12
Post a Followup	You cannot reply to this message because you are not logged in.