Subject	I believe my idle is set in Nistune to 850, but bench
Posted by	zgene4 on July 20, 2012 at 4:26 PM
	This message has been viewed 216 times.
In Reply To	Are you able to get idle down to ~750 Rpms without the posted by Evan_Wright (Ca) on July 20, 2012 at 01:16 PM
Message	testing the plates with springs attached and post installation, no sticking. If I backed the stops off completely, there was some slight sticking with the springs when snapped shut on the bench, but the release pressure was significantly less on the Rob'Z 61mm vs the original Z1 58mm because the Rob'Z bore and plate were concentric vs. the Z1 square peg, round hole fitment. WARNING: I lack industry backing
Follow Ups	Rob'Z saved my marriage - zgene4 12:58:17 07/20/12 Are you able to get idle down to ~750 Rpms without the - Evan_Wright (Ca) 13:16:52 07/20/12 I believe my idle is set in Nistune to 850, but bench - zgene4 16:26:57 07/20/12 Lol (n/m) - Evan_Wright (Ca) 17:47:58 07/20/12 About how fast is turn-around time? - ZinnZ32 13:20:56 07/20/12 Mine were the first two sets he tried and I gave him all - zgene4 16:28:14 07/20/12 He had mine back in the mail I believe the same day - spdrmn15 16:35:44 07/20/12 More humiliation for Z1, more props to Rob'Z (n/m) - whip 14:24:01 07/20/12 winning - jzx 16:36:00 07/20/12 Oval? That's strange. - DVDBURN (MD) 17:54:19 07/20/12 man these posts always make me nervous.... - Z ONLY1 18:39:46 07/20/12 I purchased mine through SZ, and had mount & sy - PiotrC70 19:31:51 07/20/12 You might want to have Rob work em over. (n/m) - ForceFedTT (SoCal) 23:24:28 07/20/12 i have a set of cast Z1 TB's, hope rob can fix the seals - ztunerz 20:41:38 07/20/12 Shaft seals? Mine leak at the shaft seals also. I wonder if - Evan_Wright (Ca) 08:59:28 07/21/12 According to Russell @ Z1 that is NOT an issue. - marklar182 14:42:23 07/21/12 does rob have a website? (n/m) - arkansasturbo 13:09:20 07/21/12 Email, and a post in the classifieds with more info (n/m) - zgene4 20:34:58 07/21/12
Post a Followup	You cannot reply to this message because you are not logged in.