Subject	AVC-R install question - ground wire setup
Posted by	awesom-o on July 16, 2012 at 10:38 AM
	This message has been viewed 412 times.
Message	Howdy all - I removed my sub-harness, which had a direct tap in extension for the AVC-R setup. Quick question from the wiring diagram in the AVC-R instructions: When I tap into the ground for the install, should the connection between the two wires be broken? Or, should I only tie into the line at the 2 separate points leaving the original connection in tact? The install is a bit unclear, and searching has been unproductive..... See below pic, should I cut the line and tie off where the arrow is or only tap into that line with both grounds?
Follow Ups	AVC-R install question - ground wire setup - awesom-o 10:38:52 07/16/12 2 points on the same wire - s3trios 10:49:43 07/16/12 Re: 2 points on the same wire - awesom-o 12:07:20 07/16/12 Ooops nvm read that wrong - s3trios 12:36:04 07/16/12 I think awesom0 put the red text in there... (n/m) - BoneZ (MD) 12:41:06 07/16/12 I did - awesom-o 13:40:49 07/16/12 Leave it intact - take a look at the AVC-R install.. - spicyZ 15:17:05 07/16/12
Post a Followup	You cannot reply to this message because you are not logged in.