Subject	Keep in mind It also depend of the spokes design...
Posted by	Oppaman Z on June 12, 2012 at 9:27 AM
	This message has been viewed 190 times.
In Reply To	I think the 10+43 sticks out only 1mm more than the 9.5+38mm posted by Jeffblue on June 11, 2012 at 03:00 PM
Message	and NO, the 285 were mounted on my other set of WORK... not on the CR Kai. You know, you may have a wheel with higher offset that will sit flush or even closer to your fenders. Next to this, 'm not totally sure of this statement but I think you will need wheel spacers on the front with your new BBK. Hope It will work fine without headache for you of course. http://www3.sympatico.ca/oppamanz/smz6.jpg
Follow Ups	need some opinions on my tire setup 255/35/18 + 285/35/18 - Jeffblue 14:28:08 06/11/12 I would run a 275/35/18 in the back but i want to maximize - Jeffblue 14:32:28 06/11/12 285/30 (n/m) - BigTDogg (MA) 14:36:32 06/11/12 with the 285/30 i'm losing so much sidewall i feel like the - Jeffblue 14:47:07 06/11/12 Not the best picture, but there is plenty of meat on a 30 - BigTDogg (MA) 10:13:01 06/12/12 Not to thread jack, but - TheMarlin 11:49:19 06/12/12 Previous owner did it - BigTDogg (MA) 12:07:45 06/12/12 agreed, 285/35 is real tall. (n/m) - Z32TT-R 17:25:39 06/11/12 Your RX7 rims stick out too much in the back... - Oppaman Z 14:48:40 06/11/12 What? A 10" +43 is pretty much perfect fit on a Z32 - BigTDogg (MA) 14:50:49 06/11/12 I guess a 285/30/18 or a 275/35/18 will allow me to run less - Jeffblue 15:05:20 06/11/12 You'll want to roll your fenders regardless. - BigTDogg (MA) 15:09:05 06/11/12 none taken i appreciate the input - Jeffblue 15:24:24 06/11/12 That will be pretty close as you can see.... - Oppaman Z 09:18:37 06/12/12 I think the 10+43 sticks out only 1mm more than the 9.5+38mm - Jeffblue 15:00:56 06/11/12 Keep in mind It also depend of the spokes design... - Oppaman Z 09:27:03 06/12/12 how would the inner clearance be on the front? - Jeffblue 15:06:17 06/11/12 Tire width may vary from different manufacturer... - Oppaman Z 09:34:30 06/12/12 Re: need some opinions on my tire setup 255/35/18 + 285/35/18 - darkmann 15:28:59 06/11/12 That actually helps a lot! - Jeffblue 15:34:57 06/11/12 Re: That actually helps a lot! - darkmann 17:48:54 06/11/12 How is the traction with the 295's - Jeffblue 17:08:37 06/11/12 Rear tires have that stressed (stretched) look though... - Z DNA 08:50:43 06/12/12 subframe spacers + 285/35 (n/m) - ZiNnYc 15:35:15 06/11/12 I run 295's on the same wheels/setup. - JMW300ZX 16:12:50 06/11/12 I ran the same setup and it worked, but the 285/35s are tall - boileralum 21:13:32 06/11/12 I'm on 285/30s on Volk GT-Ps at +45. Rolled for assurance. - HillZTT 11:05:47 06/12/12 Correction... 18x10 at +44 (n/m) - HillZTT 14:00:50 06/12/12 285/30/18 and 255/40/18 - zfreak(Dallas) 13:56:45 06/13/12 why did you decide to up the profile in the front but not - Jeffblue 15:34:01 06/13/12
Post a Followup	You cannot reply to this message because you are not logged in.