TwinTurbo.NET: Nissan 300ZX forum - The pins have multiple locations
People Seeking Info
 
   


     
Subject The pins have multiple locations
     
Posted by Joe@ZSpeedperformance on May 31, 2012 at 12:01 AM
  This message has been viewed 138 times.
     
In Reply To Just as a clarification, my clutch is the Stage 5, Feramic 6 posted by MixManMash on May 30, 2012 at 08:52 AM
     
Message The DXD flywheel will accept any Twin turbo, Non turbo or 350z Clutch kit as it is drilled with both bolt patterns.

If that clutch was slipping at 500whp there was something wrong with the adjustment of the clutch (too tight) It wasn't broken in yet or you possibly had a defective clutch (not likely) I have the same kit in cars holding 900+ to the wheels. I would have gladly taken care of it had I been contacted about it.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.