Subject	Re: Powder coating...
Posted by	toykoz32 on April 19, 2012 at 11:06 PM
	This message has been viewed 325 times.
In Reply To	Powder coating... posted by PiotrC70 on April 19, 2012 at 06:44 PM
Message	Front Cross Member Sway Bars Rear Sub frame That bracket under the exhaust Trans Gussets Trans bracket Sway bar bracket 2-piece cable stay/bracket by the battery and back of engine Fuel hard line heat shield near the rack knuckle Just about anything metal . . . .lol
Follow Ups	Powder coating... - PiotrC70 18:44:19 04/19/12 You can't remove them, so your only choice is to cure the PC - black300zx 19:10:09 04/19/12 Re: You can't remove them, so your only choice is to cure the PC - AsaHerring 22:14:37 04/19/12 They're not clips. IIRC, they let any pooled oil above the - PiotrC70 16:52:31 04/20/12 2nd, PC'er warned me they might melt, but came out fine (n/m) - FuerGrissa 23:32:05 04/19/12 Out of curiosity, how much will that run you? (n/m) - zfan21 19:20:46 04/19/12 I did the same parts. Paid $380 (n/m) - ShakaShaun(Denver) 19:52:57 04/19/12 They told me about $200 but I may need to custom order - PiotrC70 22:33:22 04/19/12 I powder coated everthing in my Engine bay (Eastwood) - Zski 22:36:28 04/19/12 Well not all of us are Ballerz like you ;) lol (n/m) - Red Hawk (CO) 15:29:49 04/20/12 You know dam well because you got the pipes I learned on... - Zski 22:23:05 04/20/12 yes a couple of things you are missing: - Zski 22:26:24 04/19/12 Damn it... forgot about the fuel lines.. THANK YOU. - PiotrC70 22:32:31 04/19/12 No Problem :) its why we are here (n/m) - Zski 22:33:49 04/19/12 Re: Powder coating... - toykoz32 23:06:17 04/19/12 One last question. On balance tube/fuel tube, is it okay - PiotrC70 23:44:44 04/19/12 With the wrinkle I would NOT PC'd the hose ends (n/m) - toykoz32 02:14:08 04/20/12 Thanks. My gut instinct was right and that's what I told - PiotrC70 09:36:02 04/20/12 No. - TK3Z32(Wi) 15:41:41 04/20/12
Post a Followup	You cannot reply to this message because you are not logged in.