Subject	Every little bit helps right? Unless you put it on a
Posted by	PiotrC70 on April 15, 2012 at 11:49 AM
	This message has been viewed 407 times.
In Reply To	Plenum port match looks like a nice DIY. I might have to posted by treese88 on April 15, 2012 at 09:47 AM
Message	flow bench, or attempt to swap the plenum in between dyno runs, it's hard to tell. I can say mathematically, that removing anywhere from 0-4mm of material from each port (since they're not quite oval) equaled in a 15-20% area increase. I just did the math for an area of an oval before/after. Either way like you said, it definitely couldn't hurt. It took me about 15min to do each port and used a small conical style sanding bit like below to polish out any roughness. [ http://www.harborfreight.com/52-piece-sanding-cone-set-96826.html ] 1993 TT. R.I.P. 09.15.2010
Follow Ups	Engine bay is finally painted and other stuff. - PiotrC70 01:37:57 04/15/12 Looks nice. (n/m) - Boosted1 06:59:04 04/15/12 So did you use any top coat in the engine bay - ZXoltan 07:37:39 04/15/12 Base coat is the QAB color, the top coat which I opted out - PiotrC70 11:25:43 04/15/12 Agreed on the glossy issue and good that you have some clear - ZXoltan 11:30:00 04/15/12 Plenum port match looks like a nice DIY. I might have to - treese88 09:47:26 04/15/12 Every little bit helps right? Unless you put it on a - PiotrC70 11:49:59 04/15/12 You prepped better for engine bay than most people do - Gordo 93TT Daytona 10:35:41 04/15/12 Engine bay looks great :) (n/m) - Zski 10:53:04 04/15/12 Nice! (n/m) - Inzane 14:13:46 04/15/12 GREAT WORK! - Look really good! - ZPHILE 21:08:54 04/15/12 looks great!!! - TReedsZ 06:18:28 04/16/12 Looks Fantastic! - Jayru 10:47:27 04/16/12
Post a Followup	You cannot reply to this message because you are not logged in.