Subject	Nice! Thanks for posting your install.
Posted by	Ash's Z on December 25, 2011 at 7:08 PM
	This message has been viewed 347 times.
In Reply To	Ash planar inlet pipes install posted by timmaz on December 25, 2011 at 04:04 PM
Message	Good to see an install where it was done with the necessary patience. We know its a tight fit and the jigs I built allow us to hold reproductions to within less than 1/16 of an inch.. Things are just so tight in that area... Do your turbo inlet pipes have the slotted bolt holes? Thanks again for the post and how you had a great christmas! Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	Ash planar inlet pipes install - timmaz 16:04:09 12/25/11 Question - VeganCannibal 16:47:13 12/25/11 larger on the maf side 76mm, 63 on the pipe side for both (n/m) - timmaz 16:52:57 12/25/11 Re: larger on the maf side 76mm, 63 on the pipe side for both - VeganCannibal 19:00:34 12/25/11 Nice! Thanks for posting your install. - Ash's Z 19:08:23 12/25/11 yes I have a set with slotted holes. Ordered from SZ. - timmaz 20:08:07 12/25/11 Only difference in the V2's from what you have now is the - Ash's Z 22:37:52 12/25/11 Nice, still lookin good. Cant wait to see u out next summer (n/m) - 300zx_2+2 23:15:39 12/25/11 did you get your swap done? - timmaz 09:19:58 12/26/11 Yup, i got it done and its a blast to mess around with the - 300zx_2+2 11:16:01 12/26/11
Post a Followup	You cannot reply to this message because you are not logged in.