Just finished up installing Ash's 2.5inch planar inlet piping. Definately a tight squeeze in some places to install the pipes, but over all not too bad. Had to grind down the drivers side motor mount some to clear the turbo pipe. Probably still gonna play with the adjustment a little bit to make them set a little better. I've got Ash's 2.5 intercooler piping ordered and in two weeks Ill order V3 Massives and a Selin setup. Moving the battery to the trunk, moving the power steering reservior back to where the battery was, adding a large power steering cooler, gonna add an adjustable FPR and move the dampner and fuel filter around (not sure where yet), AC components and heater components are gone (even the stuff under the dash). Still planning on some other stuff this winter also. Goal is 400rwhp on pump (stock turbos) by april.
Ash planar inlet pipes install - 
