TwinTurbo.NET: Nissan 300ZX forum - How would you do that and not have it taper down anyway?
People Seeking Info
 
   


     
Subject How would you do that and not have it taper down anyway?
     
Posted by dogpile on November 18, 2011 at 10:36 AM
  This message has been viewed 236 times.
     
In Reply To I think you would have quite a few buyers interested if you posted by Wright (Ca) on November 18, 2011 at 10:25 AM
     
Message From looking at those pics, you'd have to put a sleeve through the entire assembly to keep it the same size, and that would require playing with the shaft seals locations (as well as moving/redoing a few other things).

If you're saying to cut the current extended part off and just weld a larger barrel to it, you're not going to have the same size all the way through.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.