TwinTurbo.NET: Nissan 300ZX forum - Non Z. And I made my WB setup.
People Seeking Info
 
   


     
Subject Non Z. And I made my WB setup.
     
Posted by dogpile on September 05, 2011 at 7:34 AM
  This message has been viewed 259 times.
     
In Reply To Did you use a connector from an old O2 sensor and posted by BoneZ (MD) on September 04, 2011 at 10:32 AM
     
Message On my personal car I had to convert from a one-wire O2 to a 4-wire, so I had to make a new harness entirely anyway.

On the others I mentioned, the chassis side of the harness was extended (most O2 sensor wires are stainless, which you're not going to solder easily at all). Some cut and spliced to extend the chassis side, others just replaced the existing wires in the harness entirely. Really depends on the car and the person.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.