Subject	Sorry.
Posted by	DVDBURN (MD) on May 16, 2011 at 9:49 AM
	This message has been viewed 407 times.
In Reply To	<-- Classifieds (n/m) posted by spicyZ on May 14, 2011 at 07:05 PM
Message	The main info I wanted to pass along is to be very careful when plugging and unplugging nistune boards. Breaking the pins is very easy to do with these boards. If you bend a pin at or more than about a 10 degree angle it will most likely break when you try to straighten it back out. They are not very forgiving at all. If you order one and it arrives in the mail with a bent pin, take a picture of it and let Matt at nistune know before installing it. www.mytwinturbo.com Nissan Data Voice - The first Nissan diagnostic software with a voice! Download my Nissan 300ZX Vin/Model Lookup. Watch an ECZA meet caravan!
Follow Ups	Nistune board repair info. - DVDBURN (MD) 14:05:48 05/14/11 Looks good, what do you use to desolder? (n/m) - Stadsport (PHX) 15:47:16 05/14/11 You can use a desolder wick or suction device (n/m) - XTZ 12:02:58 05/15/11 not sure what he uses but i use either a Pace MBT250 or - Halo TTZ 13:26:47 05/15/11 For this I used desolder wick. - DVDBURN (MD) 09:38:44 05/16/11 can you repair my speedo? - FuerGrissa 18:38:43 05/14/11 Re: can you repair my speedo? - My Harley 22:16:57 05/15/11 Yep. - DVDBURN (MD) 09:36:22 05/16/11 <-- Classifieds (n/m) - spicyZ 19:05:05 05/14/11 Sorry. - DVDBURN (MD) 09:49:03 05/16/11 Nice (n/m) - OverZealous (CT) 13:59:29 05/16/11
Post a Followup	You cannot reply to this message because you are not logged in.