Subject	maybe, I dunno, I just roll the car up on the planks and
Posted by	LJZTT on February 28, 2011 at 1:07 PM
	This message has been viewed 381 times.
In Reply To	Why couldnt you use a lifting pad for the sill seam? posted by ZXoltan on February 28, 2011 at 10:42 AM
Message	jack it up from diff & crossbeam "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill END THE FED ....learn why, in 42 minutes Full Pardon for PFC Bradley Manning
Follow Ups	Floor jack - abckid2k 01:11:12 02/28/11 Here - XTZ 02:14:02 02/28/11 I bought mine from Harbor Frieght - Spawn 21:50:06 02/28/11 Couple of foot long 2x6's to drive up on and then buy - ttz'in (NorCal) 05:59:30 02/28/11 Not to hijack but I'm looking for a lifting pad - Fly-Surf 07:31:52 02/28/11 you dont use floor jacks on the same part of the car that - LJZTT 08:41:17 02/28/11 Why couldnt you use a lifting pad for the sill seam? - ZXoltan 10:42:56 02/28/11 maybe, I dunno, I just roll the car up on the planks and - LJZTT 13:07:05 02/28/11 yes, I used a small composit puck adapter that had a channel - zgene4 13:49:28 02/28/11 arcan + 10inch section of 2x4 - Shiers69 10:13:27 02/28/11 dayum shipping kills you due to weight... - gizmo 11:02:49 02/28/11 you could order from Costco and do a store P/U = no shipping - Cap927(Boston) 14:16:48 02/28/11 tell me about it - Shiers69 15:21:47 02/28/11 Made one from a bmw rubber jack pad that fell off. - ttz'in (NorCal) 11:53:27 02/28/11 Floor jack lift points and jack stand points from FSM... - 240Z FeO2 15:26:45 02/28/11
Post a Followup	You cannot reply to this message because you are not logged in.