Subject	you dont use floor jacks on the same part of the car that
Posted by	LJZTT on February 28, 2011 at 8:41 AM
	This message has been viewed 560 times.
In Reply To	Floor jack posted by abckid2k on February 28, 2011 at 01:11 AM
Message	you use the factory jack. Best advice is what others said about using scrap lumber. get a 3ft section and a 2 ft section of 2x8 or 2X6, 2x10, whatever makes you feel safe and stack them for use as a set of low profile ramps to drive up on. From there just about any low profile floor jack will reach under the car and still leave room for the handle to raise the car. "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill END THE FED ....learn why, in 42 minutes Full Pardon for PFC Bradley Manning
Follow Ups	Floor jack - abckid2k 01:11:12 02/28/11 Here - XTZ 02:14:02 02/28/11 I bought mine from Harbor Frieght - Spawn 21:50:06 02/28/11 Couple of foot long 2x6's to drive up on and then buy - ttz'in (NorCal) 05:59:30 02/28/11 Not to hijack but I'm looking for a lifting pad - Fly-Surf 07:31:52 02/28/11 you dont use floor jacks on the same part of the car that - LJZTT 08:41:17 02/28/11 Why couldnt you use a lifting pad for the sill seam? - ZXoltan 10:42:56 02/28/11 maybe, I dunno, I just roll the car up on the planks and - LJZTT 13:07:05 02/28/11 yes, I used a small composit puck adapter that had a channel - zgene4 13:49:28 02/28/11 arcan + 10inch section of 2x4 - Shiers69 10:13:27 02/28/11 dayum shipping kills you due to weight... - gizmo 11:02:49 02/28/11 you could order from Costco and do a store P/U = no shipping - Cap927(Boston) 14:16:48 02/28/11 tell me about it - Shiers69 15:21:47 02/28/11 Made one from a bmw rubber jack pad that fell off. - ttz'in (NorCal) 11:53:27 02/28/11 Floor jack lift points and jack stand points from FSM... - 240Z FeO2 15:26:45 02/28/11
Post a Followup	You cannot reply to this message because you are not logged in.