| The two mechanical attach points. The forward one lands right on a corner so take your time with this one. The rear one uses a supplied hole so attach that one first and then figure out the angle and drill point for the forward hole. Of course the attach points will be cleaned up and painted. :-) 
I also switched hardware to some I had hanging around. I opted for stainless with trim washer. It worked out perfect in that the washer conformed to the hole and covered the openings nicely. 
The top hardware is what it came with and the stainless below. Sorry about the fuzzy pic but you get the idea.
Here's the initial fit which is pretty good. You might get a match book between the spoiler and hatch metal. You can see the bottom edge of the spoiller needs a little alignment
 
The light is another story so but it fits real tight with no tweaking. It will require some releif around the opening to allow some wiggle room when the paint is applied.
|
Paint prep part 2 Ionic Spoiler install - 
