Subject	Oh I saw that. I wasnt sure it would work. What size is
Posted by	d_flore on July 20, 2010 at 10:47 PM
	This message has been viewed 223 times.
In Reply To	>>> posted by ztunerz on July 20, 2010 at 10:37 PM
Message	the hole. Mine gauge only came with 2 brass sized plugs. Not sure of there exact size
Follow Ups	Where to tap the oil pan (Oil temp sensor) - d_flore 21:16:21 07/20/10 just get a oil filter sandwich plate (n/m) - john90zxtt(OH) 21:20:27 07/20/10 thought about it. I would rather just get it done. This - d_flore 21:25:58 07/20/10 2nd (n/m) - CoHPhasor 21:26:35 07/20/10 Also I am sitting here with the oil drained already (n/m) - d_flore 21:28:06 07/20/10 After you tap it - SactoTodd 21:34:57 07/20/10 On a Non-Z, I had a sensor that was the drain plug. - SactoTodd 21:39:01 07/20/10 Same. i just drilled out my drain plug and tapped the middle - dogpile 08:55:31 07/21/10 I thought JDMs had an unused port plugged on the oil tree? (n/m) - evan_aggie 21:50:05 07/20/10 They do. (n/m) - zfreak(Dallas) 21:50:55 07/20/10 I had to use it for oem oil press (n/m) - d_flore 22:32:33 07/20/10 Time for a dumb question.... - evan_aggie 22:38:34 07/20/10 USDM is mounted to the oil tree port. - Draker (Eugene, OR) 01:58:30 07/21/10 >>> - ztunerz 22:37:00 07/20/10 Oh I saw that. I wasnt sure it would work. What size is - d_flore 22:47:57 07/20/10 I used a defi sensor. 1/8 not I believe. Screwed right in (n/m) - ztunerz 01:05:18 07/21/10 1/8 npt (n/m) - ztunerz 08:31:35 07/21/10 I replaced my oil pan plug with a VDO sensor. - Woody75 (Denver) 07:49:05 07/21/10
Post a Followup	You cannot reply to this message because you are not logged in.