Subject	Switching from track pads back to street pads ? >>>>
Posted by	ConVerTT on April 17, 2010 at 9:47 AM
	This message has been viewed 112 times.
Message	So I took a look at the Stoptech site. If I understand this procedure to uninstall race pads, I should simply remove them and reinstall the street pads, drive around "passively" for 5 to 20 miles to allow the street pads to abrade the race pad layer from the rotors without heating the rotors, and then re-bed the pads. Is that it? Or should I leave the race pads in for a while and let them do the work? Or does even matter (ie. is the keystone keeping the rotors cool allowing for low temp abrasion)? Thanks
Follow Ups	Switching from track pads back to street pads ? >>>> - ConVerTT 09:47:23 04/17/10 I think it depends how mild your street pad is and how - zgene4 11:36:38 04/17/10 long story short, driving passively on street pads after a - zgene4 11:39:19 04/17/10 Ahh - gotcha - so a couple of quick trips around the block - ConVerTT 11:44:03 04/17/10 exactly. Hard to keep a street pad cold, not what they're - zgene4 11:47:48 04/17/10 OK - Cool - Thanks very much (n/m) - ConVerTT 11:50:28 04/17/10
Post a Followup	You cannot reply to this message because you are not logged in.