Subject	It all can be fixed...
Posted by	Draker (Eugene, OR) on April 04, 2010 at 10:59 PM
	This message has been viewed 80 times.
In Reply To	not only did i dented it, i just looked closer posted by gbeto on April 04, 2010 at 10:31 PM
Message	Get a new pan, check the classifieds.. or buy a new one. Bolts, if stripped pull them and helicoil them. I doubt it would strip them, it would probably just break the bolts since it's going into cast iron. Either way, take a breath and take a fresh look at it tomorrow. It's a setback, but so it the entire car at times. Post some pictures and we can help more.. Oh and get a quality engine stand!!!
Follow Ups	I Efff my new tt engine. - gbeto 22:06:09 04/04/10 My pan is dented, all the valves and everything looks - ShakaShaun(Denver) 22:14:41 04/04/10 not only did i dented it, i just looked closer - gbeto 22:31:14 04/04/10 It all can be fixed... - Draker (Eugene, OR) 22:59:19 04/04/10 sucks man i know how you feel... - Figifister 01:34:05 04/05/10 go get the hf stand, $60-ish and gets the job done - LJZTT 05:07:59 04/05/10 Re: go get the hf stand, $60-ish and gets the job done - Marty1Mc 08:35:51 04/05/10 Re: Re: go get the hf stand, $60-ish and gets the job done - gbeto 12:18:00 04/05/10 I would pour gasoline on it and watch it burn. Then I'd - zellamay 12:33:06 04/05/10 Thats how I feel sometimes when working on this PITA car. - BeaZty 12:49:44 04/05/10
Post a Followup	You cannot reply to this message because you are not logged in.