Subject	way too much money for the 'gains' (n/m)
Posted by	Antihero on March 23, 2010 at 11:54 PM
	This message has been viewed 303 times.
In Reply To	My stock driveshaft is working fine. (n/m) posted by Ziceman(East TN) on March 23, 2010 at 08:11 PM
Message
Follow Ups	Aluminum driveshaft-Which one? ShaftMasters, Z1, Powertrain, - Ziceman(East TN) 18:28:08 03/23/10 I went with shaftmasters. I'm happy. (n/m) - XTZ 18:30:47 03/23/10 Did you notice a difference over the stock driveshaft? (n/m) - Ziceman(East TN) 19:02:24 03/23/10 Not really, the stock was fine. I just did it to have a new - XTZ 19:05:08 03/23/10 if your stock DS is good you're wasting your money - aliaZ 19:55:09 03/23/10 My stock driveshaft is working fine. (n/m) - Ziceman(East TN) 20:11:42 03/23/10 way too much money for the 'gains' (n/m) - Antihero 23:54:02 03/23/10 2nd. (n/m) - ZiNnYc 20:21:34 03/23/10 CF pwnz j0o (n/m) - Guapo 20:29:04 03/23/10 fishing for compliments on your shaft again? (n/m) - aliaZ 23:20:56 03/23/10 just be sure you brush afterwards (n/m) - Guapo 23:34:01 03/23/10 Don't hate... - Bernie (NoVA) 23:56:15 03/23/10 Any likelihood of a high HP Z shattering one of those while. - 91Z32TT 04:56:37 03/24/10 the yoke is glued to the CF shaft - aliaZ 07:02:54 03/24/10 Kuah broke at least one, if not two on his Z. (n/m) - zgene4 07:41:24 03/24/10 fyi, cf is a lot safer then alum/steel if it breaks (n/m) - Antihero 10:56:27 03/24/10 It is more prone to breakage, though... - SimaYi 12:38:11 03/24/10 CF driveshafts will fail sooner than aluminum or steel - zgene4 13:10:39 03/24/10 HUGE 2nd, dont invite the potential headaches if oem is good (n/m) - LJZTT 06:09:03 03/24/10 i bought a steel one piece DS - Alan(MD/NJ) 21:00:11 03/23/10 I have the Z1 Platinum and have had no issues. (n/m) - Z_Pilot (GA) 23:10:25 03/23/10 I will sell you my Z1 aluminum to help fund me buying a CF - induetime 02:22:10 03/24/10 A one-piece is not an "upgrade". Search this topic, it's - zellamay 12:30:41 03/24/10 Thanks. Looks like I will just keep my stock DS until it.... - Ziceman(East TN) 12:44:39 03/24/10
Post a Followup	You cannot reply to this message because you are not logged in.