Subject	In the absence of value, cost is the only factor.
Posted by	HighPsi on March 01, 2010 at 12:59 PM
	This message has been viewed 106 times.
In Reply To	Re: Right tool for the job posted by paintballkustoms on March 01, 2010 at 12:38 PM
Message	Obviously you have not done enough dif or tranny changes to understand the part that is being presented here. Try reading "After stripping a couple of transmission drain plugs using a 1/2" drive I started looking for the right tool for the job." You are a tool, but definetly, not the right one for the job.
Follow Ups	Right tool for the job - SlicktopTT 12:20:03 03/01/10 Re: Right tool for the job - paintballkustoms 12:38:27 03/01/10 In the absence of value, cost is the only factor. - HighPsi 12:59:23 03/01/10 lol, i freakin luv it !..........TOOL........ (n/m) - xteam300tt 14:05:36 03/01/10 I have a question for you. - na300zx (OH) 17:19:57 03/01/10 Thanks and good find. I will be ordering one. (n/m) - Ziceman(East TN) 12:39:38 03/01/10 What's your technique for removing stripped drain plugs? - Wright (Ca) 13:24:21 03/01/10 I jammed scrap pieces of thin metal in there until I had to - SlicktopTT 13:40:02 03/01/10 $10 1/2" breaker bar with end ground off works great. (n/m) - kkrofft (OH) 13:36:15 03/01/10 Not all the time, every time. I've stripped 2 and saw - SlicktopTT 13:46:49 03/01/10 Re: Not all the time, every time. I've stripped 2 and saw - ybnormal70 17:57:58 03/01/10 I took a 1/2' drive to 3/4" drive adpter & ground it to fit - Rich@RDZ 19:38:02 03/01/10
Post a Followup	You cannot reply to this message because you are not logged in.