Subject	We have them in stock available on a core exchange
Posted by	Russell@Z1 on February 24, 2010 at 2:14 PM
	This message has been viewed 154 times.
In Reply To	Re: large snap ring around the compressor housing posted by supersh0cker on February 24, 2010 at 12:59 PM
Message	basis. We disassemble used stock turbos, inspect end housings for any damage, clean and sandblast the end housings, check wastegate actuators for any problems or leaks in the diaphragm, and then reassemble with new Garrett CHRAs. Stock Turbos on 300zx.com Russell Floyd Z1 Motorsports www.300zx.com 1990+ Nissan Z specialists Used Parts, New parts, Service/Repair and Performance Z1 Motorsports Exclusive Parts Line 2877 Carrollton Villa Rica Hwy Carrollton, Ga 30116 770-838-7777 770-832-9253 (fax)
Follow Ups	any one know where to ger turbos rebuilt? - supersh0cker 04:45:11 02/24/10 It's pretty easy to change the CHRAs yourself. - na300zx (OH) 06:09:07 02/24/10 Yes, large quality snap ring pliers will make the hardest - Wright (Ca) 09:02:23 02/24/10 We have the new CHRA in stock. Changing out the CHRA - John@Z1 07:32:55 02/24/10 What are some of the hard (er) parts? TIA. (n/m) - BoneZ 10:50:58 02/24/10 large snap ring around the compressor housing - gt300zxtt 11:02:05 02/24/10 Re: large snap ring around the compressor housing - supersh0cker 12:59:54 02/24/10 If they are off the car, maybe a couple of beers. (n/m) - Woody75 (Denver) 14:05:31 02/24/10 We have them in stock available on a core exchange - Russell@Z1 14:14:57 02/24/10
Post a Followup	You cannot reply to this message because you are not logged in.