Subject	no, not stuck. Just want to make sure I understand
Posted by	Zilver TT on February 15, 2010 at 11:38 AM
	This message has been viewed 79 times.
In Reply To	They add functionality, but aren't required. posted by Boris on February 15, 2010 at 08:58 AM
Message	what's needed before attempting the install. I'll re-read the set-up instructions today but, they seem pretty straight forward: 1. Set the actuator type 2. Set the high and low boost values 3. Test and verify you hit the desired target values using a boost gauge (other than the factory one). 4. If the boost values equal what you set on the controller then you're all good. 4A.If not, start tuning using the EBC's boost correction feature. Is this process pretty close to how you set yours up? -Dustin
Follow Ups	Install and set-up experience with the HKS EVC VI? - Zilver TT 19:29:06 02/14/10 They add functionality, but aren't required. - Boris 08:58:38 02/15/10 no, not stuck. Just want to make sure I understand - Zilver TT 11:38:11 02/15/10 Yeah, pretty much. - Boris 13:31:29 02/15/10 Sounds Good. Thanks! (n/m) - Zilver TT 00:44:33 02/16/10
Post a Followup	You cannot reply to this message because you are not logged in.