Subject	I dunno, that short aluminium section seams thick enough
Posted by	Ashman2k2 on February 08, 2010 at 12:07 PM
	This message has been viewed 63 times.
In Reply To	Welding aluminum lines that are that thin and soaked in AC posted by Bernie (NoVA) on February 07, 2010 at 11:13 PM
Message	The line would be clean of oil and off the car for welding..
Follow Ups	Hey previous JDM engine buyer's and customs guru's - Sleeper_TTZ(SeKy) 17:50:54 02/05/10 I have to ask why you ordered a motor from Canada when there - Bernie (NoVA) 18:22:21 02/05/10 100% feed back. - Sleeper_TTZ(SeKy) 18:39:40 02/05/10 Typically brokerage fees end up being the responsibility of - Bernie (NoVA) 18:41:33 02/05/10 If thats the case, I'll ask for a refund through pay pal - Sleeper_TTZ(SeKy) 18:48:45 02/05/10 good luck with that (n/m) - Adam (NoVA) 19:04:51 02/05/10 I need it. (n/m) - Sleeper_TTZ(SeKy) 20:03:38 02/05/10 It wasn't from Tigerjapanese I hope? - jschrauwen 20:34:56 02/05/10 No it was jdmnagoya. (n/m) - Sleeper_TTZ(SeKy) 19:07:07 02/06/10 Import fees, duties and brokerage is typically handled by - Bernie (NoVA) 21:18:07 02/05/10 My JDM motor (90-93) came with a different - sak01 23:38:37 02/05/10 Correct - a JDM compressor doesn't fit the USDM piping. (n/m) - Bernie (NoVA) 10:15:18 02/06/10 The line from the compressor to condenser will fit perfect - Ashman2k2 22:20:57 02/07/10 Welding aluminum lines that are that thin and soaked in AC - Bernie (NoVA) 23:13:56 02/07/10 I dunno, that short aluminium section seams thick enough - Ashman2k2 12:07:19 02/08/10 That was a BAD move. - inferno 06:08:53 02/06/10 Mine came from Quebec with no additional fees approx 2 yrs - REDI4U 08:10:04 02/06/10
Post a Followup	You cannot reply to this message because you are not logged in.