Subject	Welding aluminum lines that are that thin and soaked in AC
Posted by	Bernie (NoVA) on February 07, 2010 at 11:13 PM
	This message has been viewed 70 times.
In Reply To	The line from the compressor to condenser will fit perfect posted by Ashman2k2 on February 07, 2010 at 10:20 PM
Message	oil is basically impossible for most any one to do. Bernie Bilski berniebilski@cox.net 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red ZCCNV #390 ~ ECZA #368
Follow Ups	Hey previous JDM engine buyer's and customs guru's - Sleeper_TTZ(SeKy) 17:50:54 02/05/10 I have to ask why you ordered a motor from Canada when there - Bernie (NoVA) 18:22:21 02/05/10 100% feed back. - Sleeper_TTZ(SeKy) 18:39:40 02/05/10 Typically brokerage fees end up being the responsibility of - Bernie (NoVA) 18:41:33 02/05/10 If thats the case, I'll ask for a refund through pay pal - Sleeper_TTZ(SeKy) 18:48:45 02/05/10 good luck with that (n/m) - Adam (NoVA) 19:04:51 02/05/10 I need it. (n/m) - Sleeper_TTZ(SeKy) 20:03:38 02/05/10 It wasn't from Tigerjapanese I hope? - jschrauwen 20:34:56 02/05/10 No it was jdmnagoya. (n/m) - Sleeper_TTZ(SeKy) 19:07:07 02/06/10 Import fees, duties and brokerage is typically handled by - Bernie (NoVA) 21:18:07 02/05/10 My JDM motor (90-93) came with a different - sak01 23:38:37 02/05/10 Correct - a JDM compressor doesn't fit the USDM piping. (n/m) - Bernie (NoVA) 10:15:18 02/06/10 The line from the compressor to condenser will fit perfect - Ashman2k2 22:20:57 02/07/10 Welding aluminum lines that are that thin and soaked in AC - Bernie (NoVA) 23:13:56 02/07/10 I dunno, that short aluminium section seams thick enough - Ashman2k2 12:07:19 02/08/10 That was a BAD move. - inferno 06:08:53 02/06/10 Mine came from Quebec with no additional fees approx 2 yrs - REDI4U 08:10:04 02/06/10
Post a Followup	You cannot reply to this message because you are not logged in.