Subject	See above post with subject "Start to finish I was able..."
Posted by	MixManMash on July 13, 2009 at 1:19 PM
	This message has been viewed 635 times.
In Reply To	Nice work. Question though. posted by Inzane on July 13, 2009 at 12:51 PM
Message	Specifically here: "Because my unit solves an actual conversion equation instead of referencing a lookup table, it's not subject to error from interpolation. It was tested on a superflow flowbench to be incredibly accurate all the way up to the maximum flow rating of about 850 CFM. (much more so than a single MAF alone, especially at high flow) The SAFC is a lookup table based device. I have one in my hands for testing and will share the results as they become available."
Follow Ups	Product Release - Selin Design Dual MAF Translator - CaliguyPurdue (Selin Design) 09:56:17 07/13/09 I need one for Z-Lab please! (n/m) - Dallas DamonZ 10:02:10 07/13/09 tried to email you but it bounced. - Dallas DamonZ 10:13:41 07/13/09 Strange... - CaliguyPurdue (Selin Design) 10:27:54 07/13/09 Great product, will wait till Z-Lab test results (n/m) - njz 20:23:51 07/13/09 Very nice Jim! Congrats on the launch! (n/m) - RAGTPZ 10:07:43 07/13/09 Cool idea but at that price why would someone buy it over a - ZEVAN (Ca) 10:08:09 07/13/09 The silicone elbows, is this a one piece elbow that will - ZEVAN (Ca) 10:34:50 07/13/09 2nd - DualZ (SF) 12:42:11 07/13/09 The SAFC is for elementary, basic tuning - BigTDogg (MA) 15:44:15 07/13/09 agreed, but safc2 has a knock sensor meter. - Dane (Houston) 20:47:18 07/13/09 VERY nice, Jim! - Guapo 10:10:37 07/13/09 The unit can operate in "ADD" and "AVERAGE" modes... - CaliguyPurdue (Selin Design) 10:38:03 07/13/09 very nice (n/m) - Guapo 10:41:53 07/13/09 So no need for a SAFC? You never do say. - BigTDogg (MA) 10:10:55 07/13/09 2nd GB - gt300zxtt 14:35:47 07/13/09 Other than ease of installation, what advantage, if any, - zgene4 10:17:07 07/13/09 Start to finish I was able to upgrade a single pop - CaliguyPurdue (Selin Design) 10:51:51 07/13/09 so if I am already tuned using my SAFC "Add" setup - aliaZ 11:00:37 07/13/09 OK, so this sounds really nice now, if I'm reading you right - BigTDogg (MA) 11:01:20 07/13/09 So, in a nutshell, you plug it to the EFI harness then split - JustinSCZ32 12:03:43 07/13/09 Exactly (n/m) - CaliguyPurdue (Selin Design) 12:09:06 07/13/09 Where can I find documentation that shows that safc's use - ZEVAN (Ca) 13:36:55 07/13/09 "If you've already....to install a SAFC you're already set" - jschrauwen 14:34:19 07/13/09 its for people like me who were dreading dual maf - gt300zxtt 14:37:34 07/13/09 Very nice product! Good job! (n/m) - TheTwinZ (Peru) 10:28:45 07/13/09 Great Job!!! (n/m) - Darude (Orlando) 10:32:11 07/13/09 Nice work. (n/m) - Summeronthechain (MN) 10:37:33 07/13/09 I was working on the exact same thing - pcproa 10:45:56 07/13/09 Re: I was working on the exact same thing - ali300zx 17:26:38 07/13/09 Since my product does have some differences - pcproa 18:20:34 07/13/09 Glad someone finally developed this clean solution. (n/m) - not4resaleZ 10:56:40 07/13/09 nice job Jim (n/m) - aliaZ 11:03:13 07/13/09 You sneaky, sneaky! - Spongerider :) 11:18:53 07/13/09 looks like it's time to go find another MAF. Looks great Jim (n/m) - Tu 11:29:39 07/13/09 Friggin awesome. A great product for the Z32 community! (n/m) - JustinSCZ32 11:55:33 07/13/09 Nice work. I would definitely be interested in this and the - MixManMash 12:04:39 07/13/09 Great Job Jim (n/m) - RobZ32 12:13:44 07/13/09 Well done, Jim. (n/m) - Scotts94z32 12:25:41 07/13/09 Bravo...truly awesome! (n/m) - BCs300z 12:30:32 07/13/09 Excellent! (n/m) - dpjax 12:33:26 07/13/09 Looks great Purdue! - Josher 12:34:58 07/13/09 Looks great. Saved, bookmarked, waiting for sale. (n/m) - sadairk2 12:45:54 07/13/09 Give me advice on this if you could: - J-Mart 12:49:35 07/13/09 Nice work. Question though. - Inzane 12:51:02 07/13/09 See above post with subject "Start to finish I was able..." - MixManMash 13:19:16 07/13/09 Very slick. Nicely done. (n/m) - Bernie (NoVA) 13:46:57 07/13/09 good work! (n/m) - Alan(MD/NJ) 13:55:21 07/13/09 hey caliguy, question... - NobleZ 14:00:40 07/13/09 Amazing you guys can make stuff like this. Nice job! (n/m) - collegeboy 14:16:34 07/13/09 Clever! Going on my wishlist. (n/m) - schuss 14:29:12 07/13/09 Very interested, quick question... - Fake_Blood 14:31:03 07/13/09 should be negligible difference between maf readings - gt300zxtt 14:40:41 07/13/09 Nice piece of kit - jschrauwen 14:38:39 07/13/09 Excellent thinking! (n/m) - LJZTT 14:42:11 07/13/09 If I choose to go this route... - rojoloco (San Diego) 14:50:33 07/13/09 Looks great, but as others have said cost is a problem. - greyzx 14:57:48 07/13/09 If cost is the same (I didn't purchase my SAFC), this seems - LJZTT 15:17:44 07/13/09 Far simpler install. No need to wire in an AFC - Guapo 15:23:47 07/13/09 AFC's can be had for $100 - Woody75 (Denver) 14:25:33 07/14/09 Nice. (n/m) - Southern_Z [IL][CA] ® 15:47:29 07/13/09 Re: Product Release - Selin Design Dual MAF Translator - -Grimm- 15:54:47 07/13/09 would this be useless if you - Alan(MD/NJ) 16:04:21 07/13/09 Programmed for what? You can't run Dual MAFs without - BigTDogg (MA) 16:10:20 07/13/09 Yes it can but you'll need more plumbing. (n/m) - Spongerider :) 16:29:54 07/13/09 Proof? (n/m) - BigTDogg (MA) 16:33:41 07/13/09 Re: Proof? - Spongerider :) 16:45:35 07/13/09 Yes, Dual POP. It is not possible to run a - BigTDogg (MA) 16:49:55 07/13/09 You did not read the link I gave you. It states, - Spongerider :) 16:59:13 07/13/09 Dual POP |= Dual MAF (n/m) - Eric(NJ) 17:19:17 07/13/09 Re: Dual POP |= Dual MAF - Spongerider :) 17:30:15 07/13/09 I know :-) (n/m) - BigTDogg (MA) 17:55:49 07/13/09 I tried to get you on IM, oh well. (n/m) - Spongerider :) 18:07:46 07/13/09 Not on IM much anymore, email is best (n/m) - BigTDogg (MA) 18:44:01 07/13/09 (Total Hits: a lot) - LJZTT 20:48:36 07/13/09 The thought had crossed my mind but I let it be. (n/m) - rojoloco (San Diego) 21:33:06 07/13/09 Carpe Diem Travis!! BTW finally got the Zama poster framed - LJZTT 22:03:59 07/13/09 Nice! (n/m) - rojoloco (San Diego) 08:51:06 07/14/09 No. This would be useless if you have already wired in a - Eric(NJ) 17:21:41 07/13/09 You stole my idea... JK but great minds think alike! - DEVILS Z-Tech (CA) 16:35:50 07/13/09 Looks good, but I would still need to buy a second... - pieboy100 17:35:52 07/13/09 Yes, car only comes stock with 1 maf. - boost420 09:35:14 07/14/09 Nice work. (n/m) - induetime 17:29:34 07/13/09 Very nice packaging for it. - komplexZTT 17:38:02 07/13/09 Good stuff Jimbo. I remember wiring in 2 MAFs and an AFC - ZEngineer 18:12:02 07/13/09 Congrats on a clean product. (n/m) - dregos 18:31:49 07/13/09 Awesome! Get a patent on it before Chinese copies are made! - zfreak(Dallas) 18:32:40 07/13/09 neato! - Halo Z 18:55:31 07/13/09 YES - the solution i've been looking for - Great Work! (n/m) - Medici (NorCal) 19:03:47 07/13/09 Yeah the old idea was a joke that just tried to fool the ecu - d_flore 20:02:42 07/13/09 Is it compatible with other Nissan MAF? e.g., N60 - ForceFedTT (SoCal) 21:11:40 07/13/09 N62 is the only maf for the z32. Other mafs fit but are - boost420 09:49:24 07/14/09 1v1 true but... - SeanK (StL) 10:54:53 07/14/09 Nobody is saying that it is a sub quality nissan part, - boost420 13:31:45 07/14/09 Well done Jim! (n/m) - SeedyROM 23:08:51 07/13/09 N00B. (n/m) - Halo Z 00:03:11 07/14/09 Aroo? (n/m) - SeedyROM 02:14:07 07/14/09 slick... (n/m) - moxie (SF) 00:20:51 07/14/09 Sounds Great, look forward to seeing the pics... - Cuis-Z 07:35:25 07/14/09 Thats awesome! Very neat! (n/m) - DVDBURN (MD) 08:08:22 07/14/09 Wow, Jim, that's really sweet. - TT XTZ 11:14:23 07/14/09 Damn, I am working on making something just like this... - alpha_omega16 12:22:23 07/14/09 Nice work. (n/m) - z32hp*700* 22:23:27 07/14/09 Late July is here... but your product - Cuis-Z 07:12:38 07/25/09
Post a Followup	You cannot reply to this message because you are not logged in.