| When it came time to install a dual intake on my personal 300ZX, I wasn’t satisfied with the options available to us as a community. Many of the available setups are plagued by erratic idle, inaccurate air metering, or by overly complicated and intrusive installations. Considering these drawbacks, I decided I would develop a product to overcome these shortcomings. The Selin Design Dual MAF Translator makes it easier than ever to perform a proper dual intake conversion. With true dual MAF air intake metering and plug-n-play installation this product allows you to upgrade to a dual intake without the need for an ECU re-flash or dyno tuning. You could install one in the morning and take it for a cruise that afternoon. No messing with ECU reflashing, unknown wait times, or lengthy complicated installations. If you have the classic dummy MAF setup and have been considering upgrading to a true dual MAF, the product is DIP switch selectable to work properly with dual intake tuned ECU’s. 
The design includes high quality OEM female connectors with the more modern quick release latch. The circuit enclosure features a molded in place male connector to make connection to your wiring harness easy and completely reversible. No need to run wires, cut, splice or solder… just snap it in place and you’re done. Everything is molded from glass filled polyamide plastic for strength and longevity in the automotive environment. The circuit board is fully encapsulated to protect against water, moisture, and vibration. Combined with the seals on the connectors the unit is rendered splash resistant. The mounting bracket tucks the unit away conveniently next to the filters with factory fit and finish. 
At 7000 rpm the 300ZX fires 350 cylinders per second. The ultra fast processor updates the output signal over 1000 times per second to ensure the most accurate and up to date information is available to the ECU at all times. In addition, each unit is individually serialized and tested during manufacture to have 1% or better accuracy across the entire range of operation. At every step of the design process, the focus was on uncompromised quality without excessive additional expense. While the product is not currently in stock, production is underway and units will be available in late July. In addition to the translator, I will be offering low cost silicone elbows specifically molded to fit our dual intake application. These will be available around the same time stock is available on the translators. The production brackets will be a yellow zinc finish instead of the natural steel shown. Pricing on the translator is set at $279.95 and on release will be available directly from the Selin Design website: SELIN DESIGN
 
what? It looks a little stumpy, but fits great in the hand! (n/m) - ZEngineer
12/12/06 |
Product Release - Selin Design Dual MAF Translator - 
12:45:54 07/13/09
