Subject	More Toe Setting Pics
Posted by	Gordo 93TT Daytona on April 06, 2009 at 1:51 PM
	This message has been viewed 243 times.
In Reply To	Backyard Alignment vs. Pro Shop Alignment posted by Gordo 93TT Daytona on April 06, 2009 at 12:39 PM
Message	Mockup only. Actual measurements require wheels set dead ahead straight and plastic panels fixed tight against the tires' surface. The purists among us will correctly point out the measurement should be take off the wheel lip, not the tire. However, I drive a Z, therefore, I am not pure. _________________________________________________
Follow Ups	Backyard Alignment vs. Pro Shop Alignment - Gordo 93TT Daytona 12:39:06 04/06/09 Nice - Insomniac (VA) 12:49:25 04/06/09 lol yup (n/m) - ZiNnYc 12:52:34 04/06/09 very nice! so would you suggest trusting a home allignment - KasbeKZ 13:20:56 04/06/09 For camber, yes. For toe, my apparatus needs improvement. - Gordo 93TT Daytona 13:39:23 04/06/09 More Toe Setting Pics - Gordo 93TT Daytona 13:51:17 04/06/09 way sweet! (n/m) - nemo1080 (Iowa) 16:08:47 04/06/09 This is the best toe measuremnet method i have seen - MrPulldown 17:09:59 04/06/09 That got my two plastic pieces trumped. Link Bookmarked. (n/m) - Gordo 93TT Daytona 17:26:33 04/06/09 That technique seems only as accurate as you can..... - ZaXxon 12:30:14 04/07/09 The methodology is more accurate. Use concrete blocks or - Gordo 93TT Daytona 13:44:16 04/07/09 Thoughts on measurement - lazer(NV) 14:10:29 04/06/09 i'm just wondering - RedSER13 14:40:57 04/06/09 I think that depends. A franchise alignment shop will - Gordo 93TT Daytona 15:08:51 04/06/09 Since factory spec is a range of values they usually >>>l - ZUL8TR 15:37:45 04/06/09 Yes. (n/m) - Guapo 16:10:21 04/06/09 Note that camber and toe are effected by the rim>>> - ZUL8TR 16:04:16 04/06/09 My alignment guy scores the tread surface around the tires - Gordo 93TT Daytona 17:20:22 04/06/09 Good for you to be up on the correct info, many are not (n/m) - ZUL8TR 10:18:01 04/07/09 if the ground u were parked on wasn't level, this could - nemo1080 (Iowa) 16:11:51 04/06/09 Correct. The floor must be flat and level. Not out of plane. (n/m) - Gordo 93TT Daytona 17:29:48 04/06/09 Nicely done! (n/m) - yobobrox 19:08:27 04/06/09
Post a Followup	You cannot reply to this message because you are not logged in.