Subject	Apexi question
Posted by	NightBlur on March 28, 2009 at 5:09 PM
	This message has been viewed 168 times.
Message	I just finally got around to installing my 555's today. I have t/28's in and out in the stock housing, greddy intercoolers and DP's, TP's and Borla catback. I do only have the single pop at the moment. I was looking for the best overall setting on my apexi. It was set at 1 bar and about a 65% duty cycle on factory injectors. I was looking for a few ideas on a good duty cycle. Thanks! and yes I have been searching the forum!
Follow Ups	Apexi question - NightBlur 17:09:18 03/28/09 Run 1.20 Bar Adjust the duty cycle to hit that mark on pump - jmurcybizd 17:57:36 03/28/09 Is that 'safe' advice? - ni[X]it 18:01:43 03/28/09 Hes running stock turbos buddy! are you retarded? - jmurcybizd 00:19:11 03/29/09
Post a Followup	You cannot reply to this message because you are not logged in.