Subject	I wouldn't use loctite on the studs
Posted by	aliaZ on March 13, 2009 at 8:41 AM
	This message has been viewed 79 times.
In Reply To	Did you put loctite on the threads going into the block? (n/m) posted by na300zx (OH) on March 13, 2009 at 07:45 AM
Message	unless everything is installed and torqued to spec before the loctite sets up
Follow Ups	Another one bites the dust :( Progress Report - LivinTheDream 23:03:03 03/12/09 More. sorry - LivinTheDream 23:06:15 03/12/09 Re: More. sorry - ztommyx 23:23:45 03/12/09 Either way I dont think they should get treated this way - LivinTheDream 23:34:32 03/12/09 it's 100% metal (n/m) - spyhunterTT(nj) 06:02:06 03/13/09 In your profile please set "include message in reply" to NO (n/m) - Bernie (NoVA) 01:59:00 03/13/09 g/l - gt300zxtt 23:32:40 03/12/09 Im constantly praying for patience and I think the Z - LivinTheDream 23:37:16 03/12/09 I applaud you for staying with it - FuerGrissa 00:13:01 03/13/09 Personally I'd have that motor on a stand - but g/l and take - Bernie (NoVA) 00:51:33 03/13/09 Ill eventually save up and invest in that stuff - LivinTheDream 07:20:22 03/13/09 Re: Another one bites the dust :( Progress Report - Tech@EPR 01:10:23 03/13/09 Yup. Wire brushed (gently) and all (n/m) - LivinTheDream 07:18:14 03/13/09 It looks so comfy in that binky. Sorry for your troubles. - davidztt 02:16:10 03/13/09 I didn't realize it would be possible to remove/install - na300zx (OH) 06:33:24 03/13/09 2nd. Never thought about it, cause it's so much easier to - nemo1080 (Iowa) 07:08:06 03/13/09 Its not. U have to place on the head and then screw them in (n/m) - LivinTheDream 07:16:49 03/13/09 Did you put loctite on the threads going into the block? (n/m) - na300zx (OH) 07:45:09 03/13/09 I wouldn't use loctite on the studs - aliaZ 08:41:58 03/13/09 Re: I wouldn't use loctite on the studs - na300zx (OH) 09:43:19 03/13/09 that is the correct method if you use loctite - aliaZ 09:47:29 03/13/09 I didnn't realize it wasn't necessary. - na300zx (OH) 13:07:58 03/13/09
Post a Followup	You cannot reply to this message because you are not logged in.