Subject	Yes it worked fine for me. Whenever I set mine to 4mm and
Posted by	5280Z_nightstalker on February 10, 2009 at 10:31 AM
	This message has been viewed 204 times.
In Reply To	NO. This is very poor advice. If you need to nudge posted by Guapo on February 10, 2009 at 08:45 AM
Message	then put it on even with placing a screwdriver on the mounting plate to make it tight against the belt it would expand to much once i removed the retaining screw. So after it expanded I would get 5 to almost 6mm of gap so I went under the 4mm and once it fully extended and worked its way out it was 4mm. Turned the crank a few times and it was fine. Shit I even ran the car for a few until i realized i had a oil pan leak and pulled the whole motor again. Went and measured the gap AGAIN to make sure it was cool and it was perfect. Maybe im a special case but that is what I found out worked for me to get the gap EXACTLY at 4mm and not over a mm or more
Follow Ups	Tractor bolt guy. Got her down in a day. Horror pics - LivinTheDream 23:31:02 02/09/09 Oh by the way I relised that the tension pulley didnt expand - LivinTheDream 23:35:46 02/09/09 There should be about a 4mm gap in the tensioner and the - 5280Z_nightstalker 23:46:21 02/09/09 Did it stay at 4mm once it was turned over a few times? - Woody75 (Denver) 08:07:59 02/10/09 NO. This is very poor advice. If you need to nudge - Guapo 08:45:27 02/10/09 Yes it worked fine for me. Whenever I set mine to 4mm and - 5280Z_nightstalker 10:31:28 02/10/09 Glad it worked for you. It is still not the right way - Guapo 10:34:56 02/10/09 Please don't give advice like this - it's not a smart way to - Bernie (NoVA) 11:09:44 02/10/09 nice, did you rip it down without pulling it this time? - nemo1080 (Iowa) 23:38:21 02/09/09 Didnt pull it the last time either. Did it with the block in (n/m) - LivinTheDream 07:49:25 02/10/09 replace with an ati crank pulley (n/m) - collegeboy 00:20:33 02/10/09 I bet he could find a zillion used stock pulleys for cheap - LitlElvis 06:41:31 02/10/09 hmm... (n/m) - 550HPTT 07:03:43 02/10/09 I have 2 clean stock pulleys that are correct for your car - Bernie (NoVA) 08:16:48 02/10/09 Get a new pulley.. - Drk93TT 08:56:43 02/10/09 Get a ASP UD pulley from IPP. (n/m) - Woody75 (Denver) 09:11:55 02/10/09 2nd. (n/m) - JustinSCZ32 10:05:43 02/10/09
Post a Followup	You cannot reply to this message because you are not logged in.