Subject	Re: Rear part will just be higher, bumper slightly exposed.
Posted by	jas0n3485 on December 13, 2008 at 11:38 PM
	This message has been viewed 43 times.
In Reply To	Rear part will just be higher, bumper slightly exposed. (n/m) posted by ZiNnYc on December 13, 2008 at 11:27 PM
Message	Will it be tight fit to the point where the cover is going to pull itself upward and exposing the whole rear bumper? I remember I had an old car cover where it was a snug fit, and the wind blew from behind causing the cover to blow completely off.
Follow Ups	Any one knows.... - jas0n3485 22:31:54 12/13/08 While I don't have first hand experience, I can't imagine - zgene4 22:35:56 12/13/08 I have the Stillen cover, fits fine with the Kaminari - SilverTwin(OH) 23:00:30 12/13/08 I have a oem car cover, its a very tight fit. - Multi_Read (MO) 23:17:11 12/13/08 Rear part will just be higher, bumper slightly exposed. (n/m) - ZiNnYc 23:27:36 12/13/08 Re: Rear part will just be higher, bumper slightly exposed. - jas0n3485 23:38:17 12/13/08 You can always tie down the cover - ZXRider(SoCal) 23:45:28 12/13/08 Re: You can always tie down the cover - jas0n3485 00:00:03 12/14/08 if it doesnt, make some - gt300zxtt 00:01:25 12/14/08 Word (n/m) - ZXRider(SoCal) 00:03:13 12/14/08 No it does not have holes in the cover, - ZXRider(SoCal) 00:02:43 12/14/08 Re: No it does not have holes in the cover, - jas0n3485 00:39:03 12/14/08 The factory cover has wholes, just checked, then again my Z - sleepy-z 08:01:48 12/14/08 lol... wholes* (n/m) - 550HPTT 12:23:36 12/14/08 holes* (n/m) - ZiNnYc 13:08:28 12/14/08
Post a Followup	You cannot reply to this message because you are not logged in.