Subject	you're not alone
Posted by	Dallas DamonZ on December 01, 2008 at 1:56 PM
	This message has been viewed 107 times.
In Reply To	hopefully it won't pull the threads out of the manifold posted by aliaZ on December 01, 2008 at 01:42 PM
Message	I'd rather have 4 bolts in shear on the sides installed in questionable threads than 2 bolts in tension installed in questionable threads. Later "If A equals success, then the formula is: A = X + Y + Z, X is work. Y is play. Z is keep your mouth shut." - Albert Einstein When was the last time you *really* did something with your Z to call yourself a Z enthusiast? Member #1 PETZ
Follow Ups	RameyZ Engine Sling - Madhatter10-6 13:28:46 12/01/08 hopefully it won't pull the threads out of the manifold - aliaZ 13:42:49 12/01/08 you're not alone - Dallas DamonZ 13:56:52 12/01/08 2nd - collegeboy 14:00:25 12/01/08 You are so lucky to live close to so many - KongZTT GT28RS MD 17:12:50 12/01/08 ask him about the ice cream ... (n/m) - Guapo 20:04:34 12/01/08 details details!! - KongZTT GT28RS MD 16:12:35 12/02/08 I agree - ZXRider(SoCal) 14:10:55 12/01/08 Figure 500lbs for the engine. 250 lbs per bolt on - AZHeat 14:41:15 12/01/08 I've used them on multiple motor pulls - no issues so far (n/m) - Bernie (NoVA) 15:20:14 12/01/08 3-4 years here and probably 150-200+ motors, no issues - SilverTwin(OH) 15:57:21 12/01/08 I had the same concerns, but I've used it a number of times - Guapo 16:41:39 12/01/08 Ive also used it many times with good results (n/m) - EricTTZ 22:25:36 12/01/08 Common sense would tell me if the holes I am pulling the - Spddracer 16:49:52 12/01/08 thats nice, but your common sense won't tell you - aliaZ 17:40:44 12/01/08 what? (n/m) - Guapo 20:04:11 12/01/08 I plan to use it on my next engine pull - S.Watson 14:29:29 12/01/08 Re: RameyZ Engine Sling - WazTTed 16:14:55 12/01/08 Re: what other goodies does Ramey Z make? - zgene4 17:45:27 12/01/08 Re: Re: what other goodies does Ramey Z make? - WazTTed 03:25:44 12/02/08 nylon ratchet tie down work well (n/m) - spyhunterTT(nj) 06:02:34 12/02/08
Post a Followup	You cannot reply to this message because you are not logged in.