Subject	Thanks. No problem with poking a wire if done correctly.
Posted by	DVDBURN (MD) on November 16, 2008 at 2:44 PM
	This message has been viewed 123 times.
In Reply To	Thx - good idea for putting an end to the numerious posts posted by jzack on November 16, 2008 at 12:22 PM
Message	Here is a link to many insulation piercing test leads. It's a common troubleshooting technique to poke a wire with a needle sharp test lead even in automotive work. It makes a very tiny hole and the insulation will close around it good enough to not make a difference. [ http://www.shopwiki.com/search/Insulation+Piercing+Cable+Test+Clip+Set ] (Total Mouse Over Hits: a Lot) www.mytwinturbo.com Watch an ECZA meet caravan!
Follow Ups	PTU voltage test video. - DVDBURN (MD) 23:50:39 11/15/08 Nice - thanks for the suggestion. - Bernie (NoVA) 00:04:24 11/16/08 Ha ha ha I wont lie I thought the same after his post - 5280Z_nightstalker 00:42:38 11/16/08 Why did my laptop crash when I clicked on your link? - Booster (MD) 00:30:40 11/16/08 Since it was causing problems I deleted it. - DVDBURN (MD) 10:35:47 11/16/08 I love the voltage tester but the linked video doesn't - 240Z FeO2 01:13:31 11/16/08 Here is another version of the video. - DVDBURN (MD) 10:21:11 11/16/08 Thx - good idea for putting an end to the numerious posts - jzack 12:22:56 11/16/08 Thanks. No problem with poking a wire if done correctly. - DVDBURN (MD) 14:44:26 11/16/08 Statement correction. - DVDBURN (MD) 16:06:47 11/16/08
Post a Followup	You cannot reply to this message because you are not logged in.