Subject	Re: assuming it runs and makes good compression, at the very
Posted by	ooofoo on September 29, 2008 at 9:49 PM
	This message has been viewed 95 times.
In Reply To	assuming it runs and makes good compression, at the very posted by zgene4 on September 29, 2008 at 09:42 PM
Message	Don't know that it runs. Was more of an impulse buy than anything. I just ohm tested the injectors and thus far 4 out of 6 are good. Gonna try to take a wire brush to the others just to make sure the corrosion isn't preventing continuity. What are the main signs of damage that I should be looking for is basically what I'm asking, along with other recommendations. Thanks for the reply.
Follow Ups	Purchased a TT engine for 100 bucks, now what? - ooofoo 21:38:27 09/29/08 assuming it runs and makes good compression, at the very - zgene4 21:42:37 09/29/08 Re: assuming it runs and makes good compression, at the very - ooofoo 21:49:05 09/29/08 Break it down completely and take the bare block, crank - Agner.S(CT) 21:50:29 09/29/08 Oh!, you aren't wanting to do a rebuild. Just a basic - Agner.S(CT) 21:54:49 09/29/08 Re: Oh!, you aren't wanting to do a rebuild. Just a basic - ooofoo 21:58:30 09/29/08 your eyeballs dont matter much in the long run - gt300zxtt 22:59:52 09/29/08 First, lets just hope you get the engine. - Waggz 22:11:22 09/29/08 I think he already has it.... - 240Z FeO2 22:48:33 09/29/08 50 bucks for a used engine stand? - Bret (Generation Z) 00:36:05 09/30/08 hmmm... - AntiHero 11:30:12 09/30/08 Re: hmmm... - ooofoo 16:17:25 09/30/08 Do a leakdown test. that'll let you know where you stand. (n/m) - 1badz32 (MN) 17:53:25 09/30/08
Post a Followup	You cannot reply to this message because you are not logged in.