Subject	Hi members, I've been fixing up a 1990 300zx NA.
Posted by	93 Blue Z32(NC) on September 24, 2008 at 1:34 AM
	This message has been viewed 829 times.
Message	Since I've had the Z I have done the following, pressure washed the Z 3 times. Inside wiped down. Motor removed because bad connecting rod bearing's, etc. Motor compartment pressure washed many time's. Replaced old roted power steering hoses. Replaced engine wire harness with 95 tt harness. Polished heat shields inside motor compartment. replaced bent tie rod and installed new boots. installed new exhaust o rings for down pipes. replaced front driver side wheel bearing and seal. Installed new rotors and brake pads. installed new caliper shim kits (front and rear) repainted caliper's Installed oem rim's on Z with new lug bolts install 95 alternator because of old alternator was phasing. install new radiator, etc. install aftermarket oil gauge. repainted fender wells cleaned up aluminum parts to look new again installed new antenna unit installed energy suspension rack and pinion bushings painted motor, etc polished anything aluminum replaced exhaust studs (Now that's a pain in the Ass) New transmission release bearing and pilot bearing The Replacement Motor 93 VG30DE NA motor from my 300zx. I had machine shop rebuild heads new valve seals valve's reground 5 angle grind heads resurfaced pressure tested, etc. checked run out, etc. AND THE BLOCK block cleaned, etc. new main bearings new connecting rod bearings crank polished new ring's block horned New Gaskets for entire motor, etc, etc. I reassemble the motor myself to spec. LEFT TO BE DONE Aline front end replace some more power steering hose's Find lower engine shield and install replace transmission rear main seal replace interior install radio and replace speaker's install HID lighting system install carbon fiber hood repire some wiring issues fix door hinges repair locks check fluids replace lights in deck lid replace lights for license plate REPAINT CAR ">
Follow Ups	Hi members, I've been fixing up a 1990 300zx NA. - 93 Blue Z32(NC) 01:34:59 09/24/08 hey man im local to Wilmington NC too - volcomstone550 02:01:13 09/24/08 Re: I replace work on Ab's Nissan's. I heard you did a upgrade - 93 Blue Z32(NC) 08:12:33 09/24/08 yea i think ab put one in. come check out my car sometime - volcomstone550 22:18:40 09/24/08 Re: Hi members, I've been fixing up a 1990 300zx NA. - Z300Z 03:52:13 09/24/08 Im in the Tri-cities (TN)... - WAM_Z32 22:43:41 09/24/08 Rule #1 never pressure wash that motor, way too many areas - sleepy-z 05:00:45 09/24/08 The old motor was pressure washed before I would touch the Z - 93 Blue Z32(NC) 08:20:15 09/24/08 Still a very bad idea. What you saw was probably the - BigTDogg (MA) 08:58:57 09/24/08 no, i think he means he had layers of caked on dirt similar - gt300zxtt 11:10:19 09/24/08 cool, would love to see it at the Nov 1 Crossroads show in - BOOZT_JUNKIE 07:11:00 09/24/08 You should throw that harbor freight leakdown tester away (n/m) - 91Z32TT 11:56:10 09/24/08 It's a good tool for listening for Air. Who makes a better - 93 Blue Z32(NC) 12:21:31 09/24/08 Listening for air yes - but for actual leakdown - 91Z32TT 13:58:05 09/24/08
Post a Followup	You cannot reply to this message because you are not logged in.