Subject	Sport500s should spool up way before 4500 rpms (n/m)
Posted by	amp300zx on September 16, 2008 at 7:34 PM
	This message has been viewed 58 times.
In Reply To	Dyno Results - Suggests and Comments Greatly Appreciated. posted by ooofoo on September 15, 2008 at 08:08 PM
Message
Follow Ups	Dyno Results - Suggests and Comments Greatly Appreciated. - ooofoo 20:08:10 09/15/08 whoa! - s3trios 20:13:46 09/15/08 a few suggestions - spyhunterTT(nj) 20:21:25 09/15/08 nice sig pic (n/m) - komplexZTT 21:07:28 09/15/08 no - Guapo 21:10:33 09/15/08 i still think it's a good idea, even at running pump gas - spyhunterTT(nj) 05:49:19 09/16/08 that is a silly idea - aliaZ 06:43:16 09/16/08 2nd, mulitple tunes for multiple fuels. Don't mix and match (n/m) - BigTDogg (MA) 10:27:12 09/16/08 Well perhaps I'm wrong - spyhunterTT(nj) 17:22:37 09/16/08 Re: Well perhaps I'm wrong - aliaZ 22:55:48 09/16/08 No downpipes/Testpipes? - Drk93TT 20:37:10 09/15/08 Re: No downpipes/Testpipes? - ooofoo 20:51:49 09/15/08 Wow. They seem very low. I was very close to that... - scottyfender 21:27:26 09/15/08 that sucks - the80proof 01:17:40 09/16/08 I concur they seem a bit low - Summeronthechain (MN) 21:54:55 09/15/08 I think Mustang dynos are always a lot lower than - citation 22:17:51 09/15/08 VERY low - Alex_SlicktopTT (WA) 01:08:47 09/16/08 Mustang dyno * 1.2 ~ Dynojet dyno (n/m) - spyhunterTT(nj) 05:50:17 09/16/08 this is 3rd z so far i seen with low numbers on sp500's - ricky6991 01:32:37 09/16/08 youve just been seeing sick cars. - AntiHero 08:13:49 09/16/08 you've seen 3 poorly running cars as stated^^^ (n/m) - LJZTT 11:37:41 09/16/08 I hit 435 @ 17psi on my old Z... - Shift_(ATL) 19:41:08 09/16/08 I've made more on stock turbos. You have fuel issues - BigTDogg (MA) 09:03:42 09/16/08 Agree, those numbers are way too low. (n/m) - Milo (SATX) 11:07:28 09/16/08 mine before dp, tp, and pulley. actual boost was ~16psi. - RedSER13 09:16:51 09/16/08 Sport500s should spool up way before 4500 rpms (n/m) - amp300zx 19:34:24 09/16/08
Post a Followup	You cannot reply to this message because you are not logged in.