Subject	Don't worry, I didn't damage one
Posted by	na300zx (OH) on September 09, 2008 at 9:47 AM
	This message has been viewed 68 times.
In Reply To	Those wheels took a LONG time to get :-( (n/m) posted by ImTheDevil on September 09, 2008 at 08:51 AM
Message	My plan is to eventually widen the fronts and rears an inch so I can run 275 front and 315 rear. You'll see them when they get done. I'm sure you'll love it. The rears will be getting an extra inch toward the inside, but the fronts need slightly less offset to match the rears more closely, so I think the easiest way will be to change the outer section with one that has slightly more lip. (~40mm vs. 27mm) The front will get widened in both directions due to that.
Follow Ups	Volk GT series wheels - na300zx (OH) 09:14:05 09/08/08 I assume they are for the same diameter wheel, however, - Scotts94z32 10:24:20 09/08/08 I was under the assumption that powdercoating the - Twindragon 10:56:48 09/08/08 Not that I doubt luke's knowledge, but I don't see any - BigTDogg (MA) 10:58:40 09/08/08 Same reason why you shouldn't re-use cylinder head - olyar15 14:19:02 09/08/08 I'm not buying it. But if I were, I'd REALLY be buying it - BigTDogg (MA) 14:21:05 09/08/08 Thanks. (n/m) - na300zx (OH) 13:07:00 09/08/08 Those wheels took a LONG time to get :-( (n/m) - ImTheDevil 08:51:19 09/09/08 Don't worry, I didn't damage one - na300zx (OH) 09:47:36 09/09/08
Post a Followup	You cannot reply to this message because you are not logged in.