Subject	The metal is the same, some of the fittings are different.
Posted by	just4kinks on August 27, 2008 at 10:43 AM
	This message has been viewed 129 times.
In Reply To	differences in Rear knuckles posted by MrPulldown on August 27, 2008 at 02:33 AM
Message	The TT has a Hicas ball joint where the NA has a rubber bushing. I had a hell of a time pressing the ball joint into the NA knuckle, it's possible that the hole is slightly (like .5mm) smaller on the NA. The wheel bearing dust seal is a little larger for the TT. This is easy to swap. Everything else is exactly the same (as close as I could measure). I swapped the knuckle from a 91NA to a 95TT. I'm talking about the knuckle itself -- obviously the bearing & other stuff that attaches to it are different.
Follow Ups	differences in Rear knuckles - MrPulldown 02:33:03 08/27/08 TT & NA don't really interchange. - Bernie (NoVA) 02:35:20 08/27/08 Actually, those NA knuckles you sold me are on my TT - just4kinks 10:34:13 08/27/08 Even better. (n/m) - Bernie (NoVA) 11:24:49 08/27/08 The metal is the same, some of the fittings are different. - just4kinks 10:43:03 08/27/08 Thanks Anything different about the years? - MrPulldown 10:59:16 08/27/08 I'm not sure about the '90, but the parts fiche - just4kinks 13:13:04 08/27/08 Thanks for clearing that up. (n/m) - Bernie (NoVA) 11:25:48 08/27/08
Post a Followup	You cannot reply to this message because you are not logged in.