Subject	Second the Mar Hyde prep and follow with an etching prime on
Posted by	z32bob on August 22, 2008 at 11:18 AM
	This message has been viewed 170 times.
In Reply To	you can wipe with acetone or some mar-hyde prep all (n/m) posted by LaRose on August 22, 2008 at 10:08 AM
Message	The bare metal .Dupont Variprime Part #s 615 and 620 converter would be my first choice . When using the MarHyde prep use 2 sets of towels ,One wet with the prep the other dry .Dont just wipe it and let it dry on its own !
Follow Ups	Need Some Advise With Prepping For Paint... - Chad M (CA) 10:06:07 08/22/08 you can wipe with acetone or some mar-hyde prep all (n/m) - LaRose 10:08:42 08/22/08 Second the Mar Hyde prep and follow with an etching prime on - z32bob 11:18:19 08/22/08 getting the dust off with water is fine, dry it off - CRAZZEPETE. 10:09:15 08/22/08 I would just use a little bit of rubbing alcohol on a clean - Waggz 10:15:30 08/22/08 If I had to guess I would say its an Xterra. (n/m) - 300MPH 10:26:03 08/22/08 2nd (n/m) - BannonZ 15:44:35 08/22/08 Yup thats an Xterra (n/m) - Chad M (CA) 21:12:02 08/22/08 Acetone it then primer. (n/m) - awesom-o 10:58:00 08/22/08 Wipe it down with Dupont Prep-Sol (n/m) - Pats300zx 11:28:07 08/22/08 Seal with a good primer then hit with rubber undercoating (n/m) - REDI4U 11:44:16 08/22/08 NO rubber undercoating the new urethane/tape will not stick - z32bob 12:28:08 08/22/08 Down to the metal isn't a big deal, you could technically - TriniTT 12:46:35 08/22/08 trust me the double stick tape adheres to anything also use - REDI4U 13:43:58 08/22/08 Thats a bit broad of a statement (n/m) - 550HPTT 16:22:07 08/22/08 mineral spirits to prep - spyhunterTT(nj) 20:10:11 08/22/08 Mineral Spirits? ... Is that the same as distilled water? (n/m) - Chad M (CA) 21:10:39 08/22/08 No, it's the souls of dead minerals... - Waggz 22:36:12 08/22/08 it's more or less a solvent, aka paint thinner (n/m) - spyhunterTT(nj) 07:13:37 08/23/08
Post a Followup	You cannot reply to this message because you are not logged in.