Subject	Rhino ramps are too high for my lowered (0.8") Z,
Posted by	just4kinks on August 17, 2008 at 12:09 AM
	This message has been viewed 91 times.
In Reply To	No issues with sliding out? You can drive right onto them? posted by LJZTT on August 16, 2008 at 08:21 PM
Message	but they worked fine when it was stock. They do slide sometimes. There is a little rubber pad in the front of the ramp that's supposed to keep it from sliding, but it doesn't always work.
Follow Ups	Ramps, any recommendations? Or are they all the same? - LJZTT 20:10:15 08/16/08 I have had the same rhino ramps for 10 years, they have - ShakaShaun(Denver) 20:13:16 08/16/08 No issues with sliding out? You can drive right onto them? - LJZTT 20:21:26 08/16/08 not normally. today I put the car up on them and the tires - ShakaShaun(Denver) 20:49:52 08/16/08 Darn rain sucks dont it? Cant race in it and cancelled a - 5280Z_nightstalker 00:08:50 08/17/08 Rhino ramps are too high for my lowered (0.8") Z, - just4kinks 00:09:37 08/17/08 how do you make that thing stay put? (n/m) - RedSER13 18:36:15 08/17/08 I drilled two each 2x2 x10" long into the garage floor to - Gordo 93TT Daytona 19:59:52 08/17/08 ^^this is what I needed to know - LJZTT 12:28:44 08/18/08 Some ramps have square rubber 'grippers' on the bottom - Gordo 93TT Daytona 22:42:01 08/18/08 I use Race Ramps - RICH1 21:27:53 08/16/08 Rhino ramps.. first "tool" I bought ever for my Z.. - KongZTT GT28RS in TX 8/28-9/4 22:19:35 08/16/08 Make your own. (n/m) - Bernie (NoVA) 22:41:05 08/16/08 Don't own ramp-making tools. - LJZTT 23:17:39 08/16/08 All you need is a hammer and some nails. (n/m) - Bernie (NoVA) 07:57:39 08/17/08 No ramp tools, and yet you link to the MANtage...weak - BigTDogg (MA) 10:22:50 08/17/08 i dont understand how rhino ramps are working for you guys - AntiHero 00:33:57 08/17/08 I put a 2x6 down on the ground. that is about 3' long.. - KongZTT GT28RS in TX 8/28-9/4 07:00:06 08/17/08 Wouldn't it be easier to just add on to that 2x6 :) - Woody75 (Denver) 19:59:41 08/17/08 :) damn you! (n/m) - KongZTT GT28RS in TX 8/28-9/4 23:24:27 08/17/08 I tried this, though I sandwiched plywood between the layers - LJZTT 12:34:25 08/18/08
Post a Followup	You cannot reply to this message because you are not logged in.