Subject	not normally. today I put the car up on them and the tires
Posted by	ShakaShaun(Denver) on August 16, 2008 at 8:49 PM
	This message has been viewed 88 times.
In Reply To	No issues with sliding out? You can drive right onto them? posted by LJZTT on August 16, 2008 at 08:21 PM
Message	were wet they slipped out once, not a normal thing. Good people drink good beer.
Follow Ups	Ramps, any recommendations? Or are they all the same? - LJZTT 20:10:15 08/16/08 I have had the same rhino ramps for 10 years, they have - ShakaShaun(Denver) 20:13:16 08/16/08 No issues with sliding out? You can drive right onto them? - LJZTT 20:21:26 08/16/08 not normally. today I put the car up on them and the tires - ShakaShaun(Denver) 20:49:52 08/16/08 Darn rain sucks dont it? Cant race in it and cancelled a - 5280Z_nightstalker 00:08:50 08/17/08 Rhino ramps are too high for my lowered (0.8") Z, - just4kinks 00:09:37 08/17/08 how do you make that thing stay put? (n/m) - RedSER13 18:36:15 08/17/08 I drilled two each 2x2 x10" long into the garage floor to - Gordo 93TT Daytona 19:59:52 08/17/08 ^^this is what I needed to know - LJZTT 12:28:44 08/18/08 Some ramps have square rubber 'grippers' on the bottom - Gordo 93TT Daytona 22:42:01 08/18/08 I use Race Ramps - RICH1 21:27:53 08/16/08 Rhino ramps.. first "tool" I bought ever for my Z.. - KongZTT GT28RS in TX 8/28-9/4 22:19:35 08/16/08 Make your own. (n/m) - Bernie (NoVA) 22:41:05 08/16/08 Don't own ramp-making tools. - LJZTT 23:17:39 08/16/08 All you need is a hammer and some nails. (n/m) - Bernie (NoVA) 07:57:39 08/17/08 No ramp tools, and yet you link to the MANtage...weak - BigTDogg (MA) 10:22:50 08/17/08 i dont understand how rhino ramps are working for you guys - AntiHero 00:33:57 08/17/08 I put a 2x6 down on the ground. that is about 3' long.. - KongZTT GT28RS in TX 8/28-9/4 07:00:06 08/17/08 Wouldn't it be easier to just add on to that 2x6 :) - Woody75 (Denver) 19:59:41 08/17/08 :) damn you! (n/m) - KongZTT GT28RS in TX 8/28-9/4 23:24:27 08/17/08 I tried this, though I sandwiched plywood between the layers - LJZTT 12:34:25 08/18/08
Post a Followup	You cannot reply to this message because you are not logged in.