Subject	Turn the entire shock body to raise/lower the car. The
Posted by	WoodmanZ on August 16, 2008 at 1:10 PM
	This message has been viewed 115 times.
In Reply To	Tein FLEX install..Not sure if its safe in tech forum yet.. posted by Kong ZTT GT28RS MD on August 16, 2008 at 08:07 AM
Message	collar on the bottom of the spring is to set the spring preload. This needs to be done after you set the height to where you want it. Preload is basically where the spring has just enough tension on it, but not too much. If there is too much tension, the ride will be harsh. If there is not enough, then when you go over a dip, or low bump, then the spring could actully come completely off its seat if the shock is at full expansion.
Follow Ups	Tein FLEX install..Not sure if its safe in tech forum yet.. - Kong ZTT GT28RS MD 08:07:03 08/16/08 mini-meet I heard of around 29 Aug - 1 Sept - LJZTT 09:05:06 08/16/08 4.5 hours one way is not a "short drive from dallas" (n/m) - ni[X]it 09:06:59 08/16/08 "...just when they're about to catch me..." (n/m) - LJZTT 09:09:24 08/16/08 "...twin..." (n/m) - en5 13:48:11 08/16/08 i honestly did it the way you described by turning the body - mogaffar 09:09:05 08/16/08 btw if you look in the manual it tells you how to do it and - mogaffar 09:18:36 08/16/08 manual inside*** - mogaffar 14:29:36 08/16/08 Re: Tein FLEX install..Not sure if its safe in tech forum ye - outkaZTT 10:44:50 08/16/08 Turn the entire shock body to raise/lower the car. The - WoodmanZ 13:10:06 08/16/08 use about 1/4 inch preload. (n/m) - SuparexTT 14:19:04 08/16/08 yeah theres an exact measurement of the preload in the manua (n/m) - mogaffar 14:27:27 08/16/08
Post a Followup	You cannot reply to this message because you are not logged in.