Subject	im hoping to get one sometime next year...
Posted by	Medici (NorCal) on August 08, 2008 at 10:59 AM
	This message has been viewed 80 times.
In Reply To	Must be the angle of the picture because the car looks quite posted by Dave N on August 08, 2008 at 10:44 AM
Message	just have to redirect some of the money from the TT - hehe i loved working on it, it was so basic. -
Follow Ups	Recognize this flywheel? - Medici (NorCal) 08:32:52 08/08/08 match it up to a TT flywheel, we can't do anything - CRAZZEPETE. 10:08:53 08/08/08 good point, any idea on the manufacturer though?? (n/m) - Medici (NorCal) 10:25:42 08/08/08 What on earth did you do to the 240Z in your sig pic?! - Dave N 10:17:52 08/08/08 hehe - if you look closely you can see jack stands on ps - Medici (NorCal) 10:24:37 08/08/08 Must be the angle of the picture because the car looks quite - Dave N 10:44:10 08/08/08 im hoping to get one sometime next year... - Medici (NorCal) 10:59:48 08/08/08 Something like that... - en5 12:36:13 08/08/08 jwt or fidanza to start - gt300zxtt 10:47:57 08/08/08 not fidenza, I have that one, blue says ABflug to me - CRAZZEPETE. 10:49:42 08/08/08 i was going on bolt alignment mainly, not color - gt300zxtt 10:54:15 08/08/08 I hear ya, but we're asked to guess, so lets keep tryin (n/m) - CRAZZEPETE. 11:00:31 08/08/08 Clean it, perhaps you will find some kind of ID? (n/m) - BlackholeZ 10:55:01 08/08/08 I looked over it pretty well, though you're right. (n/m) - Medici (NorCal) 11:01:15 08/08/08 I just wiped it down - no s/n part number - nothing (n/m) - Medici (NorCal) 11:07:31 08/08/08 next idea, e-mail some vendors. - BlackholeZ 11:21:19 08/08/08 hmm, if thats the case its likely discontinued. - Medici (NorCal) 11:31:48 08/08/08 stillen?? - BradleyTT(OK) 11:31:31 08/08/08 Jackpot - thanks Bradley! Gonna send stillen an email - Medici (NorCal) 11:39:12 08/08/08 thats the same flywheel - gt300zxtt 11:47:23 08/08/08 thanks (n/m) - BradleyTT(OK) 14:43:09 08/08/08 measure it (n/m) - spyhunterTT(nj) 17:01:14 08/08/08
Post a Followup	You cannot reply to this message because you are not logged in.